3Built RES12VX Посібник - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник для Приймач 3Built RES12VX. 3Built RES12VX 5 сторінок.

Programming requires the use of a Programming Transmitter that is available on our website.

PROGRAMMING

1) Disconnect power from the Receiver for 30 seconds.

2) Have the new Transmitter and the Programming Transmitter ready. They will both be

used within a few seconds once power is applied to the Receiver.

3) Apply power to the Receiver (should be two beeps {programmed} or three beeps

{erased}) and continue to next step within 5 seconds.

4) Press the white LOCK button on the Programming Transmitter. The receiver will emit

two beeps to signal that it is ready to be programmed. Continue to the next step within 5

seconds.

5) Press the "Lock" button on the new Transmitter. The receiver will emit one beep.

6) Press the "Unlock" button on the new Transmitter. The receiver will emit three beeps.

7) Optional - If more than one transmitter is being programmed to the receiver, repeat Step

5 and 6 until all transmitters have been programmed (Limit of 20)

8) Disconnect the power to the Receiver for a few seconds.

9) Connect power to the Receiver and test new Transmitter function.

ERASE RECEIVER

1) The Receiver's memory can be entirely erased by disconnecting power (30 seconds)

and reconnecting power to the Receiver.

2) Immediately after power is connected, press the white UNLOCK button on the

Programming Transmitter until the receiver emits six short beeps to confirm complete

deletion of all transmitter programming.

Receivers with a "C" in the part

number

(for example: RES12VCE, RES6VCE)

Program button

Erase Button

Page 4 of 5

6/28/16