Aquatec ERP 500 Інструкція з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Водяний насос Aquatec ERP 500. Aquatec ERP 500 4 сторінки. Permeate pump

ERMEATE

UMP

NSTALLATION INSTRUCTIONS

This is the side of the pump that the brine ( waste water)

connections are made.

After your flow restrictor on the waste line on the way to the drain

you install this side of the pump. Run a tube from the flow

restriction on your unit to the brine in port on the pump. Then run a

tube from the brine out port of the pump to the drain.

Remember the out port must be up when compared to the in port.

With the out port in the up position no air can remain trapped in the

pump.

The ports are marked check the pump label.

This is the permeate ( pure water ) side of the pump. This side is

installed between the membrane and the final filter or the storage

tank.

Permeate ( pure water ) from the membrane is connected to the

permeate in port. The permeate out port connects to one side of the

final filter or to the storage tank. Most systems have a tee on the inlet

of the final filter connect to that tee.

When you combine the white clip with the black clip you can mount

the pump directly onto the membrane housing.

You may use fittings to make the connection or you can simply push

tubing into the ports.

These are push-in fittings and

you just firmly push the tube into

place.

If you want to remove the tube,

First push in on the tube, hold

down on the fitting collar with

your thumb nail and pull lightly

on the tube. If you have properly

held the collar down then the tube

will slip out pretty easily.