Aquatec HydroPro HZ2010 Посібник із швидкого старту - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Водяний насос Aquatec HydroPro HZ2010. Aquatec HydroPro HZ2010 13 сторінок. Air pumps
Друкувати сторінкуCHANGING DIAPHRAGMS
If the air flow on the pump has decreased or if there is a "ticking"
sound coming from the air pump, the unit must be turned off
immediately. This is typically a symptom of the rubber diaphragms
wearing out and needing to be replaced. To do this, it is necessary
to disassemble the internals of the air pump.
1. Flip the air pump so it's upside down and locate the 4-Phillips
screws on the bottom portion of plastic casing and loosen.
2. Once the screws have been removed, go ahead and remove the
top section of plastic casing from the bottom and set aside.
3. Now looking at the internals, go ahead
and undo the Philips screws that hold
the rubber diaphragm and magnet
assembly to the bottom portion of
plastic casing. Set screws aside in
a secure location and firmly apply
pressure to lift the rubber diaphragm
and magnet assembly off of the base.
HPRO Air Pump Z2010_Z4010 Instructions.indd 6
V I S I T A Q U A T E C E Q U I P M E N T . C O M
22/2/19 11:07 am