Diamond H2O DCF6-18-125 Посібник з монтажу, експлуатації та технічного обслуговування - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з монтажу, експлуатації та технічного обслуговування для Системи фільтрації води Diamond H2O DCF6-18-125. Diamond H2O DCF6-18-125 18 сторінок. Activated carbon water filter system

Друкувати сторінку

3. GENERAL INSTALLATION INSTRUCTIONS

3.1.

LOCATION

1. Select a position near a floor drain that has adequate carrying capacity to handle the filter

backwash flow rate. Refer to the Specification Table on page 2 for the backwash flow rate.

2. Erect the filter on a level, firm foundation, preferably concrete. The valve and piping are

normally in front.

3. Level the system.

3.2.

MECHANICAL

NOTE: Please verify that you have the proper amount of gravel and media on site before

proceeding. If the amounts of gravel and media on site differs from what is listed in

the Systems Specification table contact Diamond H2O for the correct amount.

NOTE: The control valve and bypass are designed to accommodate minor plumbing

misalignments but are not designed to support the weight of a system or the

plumbing.

1. Thoroughly read and comply with the

instructions provided in this manual.

2. Thread the control valve onto the fiberglass tank

to determine the correct "Front Orientation".

Mark the location on the tank with tape.

Note: After the gravel and media are loaded it is

very difficult to move or rotate the tank.

3. Remove the control valve and install the PVC

distributor system into the tank.

4. Locate the tank, with the proper front

orientation, and then fill the tank approximately

half full of water.

5. Cover the exposed end of the distributor pipe to

prevent any gravel and/or media from falling into

the riser.

N1022 Quality Drive

Diamond H2O

PO Box 170

Ph: (920) 757-5440 / (866) 757-9287 / Fax: (920) 757-5819

Greenville, WI 54942

Page 2