Setting for Barcode Reader
The following menu opens by clicking
Connection to Barcode
(Power Saving Mode)
Connection to Barcode
(Always-On)
Disconnect Barcode Module
Confirmation Message On
Add Enter-Key code
Exit 1D Barcode Key Emulator
The confirm message is closed in the following cases.
*1
When five seconds pass from the display message.
•
When the [Close] in the message window is clicked.
•
When the trigger button is pushed again.
•
NOTE
When the computer enters Sleep (Model with Windows Vista)/Standby (Model with
Windows XP) or Hibernation in Power Saving Mode or Always-On mode, the Barcode
Reader is disabled. [Barcode Module was disconnected by changing the power status]
message appears at the next resume timing.
In Power Saving Mode, click [OK] to reconnect with the Barcode Module.
•
In Always-On mode, click [OK] and select [Always-On] again from the above menu to
•
reconnect with the Barcode Module.
When the computer is shut down in Power Saving Mode or Always-On mode, the
Barcode Reader is disabled.
In Power Saving Mode, just turn on the computer to reconnect with the Barcode
•
Module.
In Always-On mode, the Barcode Module is not reconnected only by turning on the
•
computer. Select [Always-On] again from the above menu.
The
icon may not appear when you start up the computer for the first time. In this
case, restart the computer.
icon on the notification area.
To reduce the power consumption, stop barcode reader
operation within 1 minute after reading a barcode.
Keep barcode reader active even after reading a barcode.
Stop barcode reader operation in Always-On mode.
If the trigger button is pressed in Power Saving Mode, "Push
Barcode Trigger again to enable Barcode." message is dis-
played.
*1
Add a line feed code after a barcode string.
Exit barcode reader operation.
3
Друкувати сторінку