Aquatec Equipment AQUAPRO 02AS512 Інструкція з експлуатації - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Сонячна панель Aquatec Equipment AQUAPRO 02AS512. Aquatec Equipment AQUAPRO 02AS512 13 сторінок. Solar panel & submersible pump kit
Друкувати сторінкуPRODUCT SPECIFIC SAFEGUARDS
• Do not operate the pump without water at any time, permanent damage may occur.
• Be sure the equipment is submerged completely in the water. Do not use this pump in a dry mounted
application.
• The pump is designed to be used in a fresh water bird bath or water-feature. It is not to be used in
any other manner or purpose. The pump should only be used in clean water. Do not use the pump in,
or with, any chemicals such as a solvent or gasoline.
• Aquapro DC Solar Pumps are cooled by water flowing through the inside of the motor body. If the
pump flow becomes restricted it will overheat and could cause permanent damage. The pump needs
to be cleaned regularly to prevent the pump becoming blocked, thus causing the pump to overheat
and burn out. This is not a warrantable event. The flow rate through the pump needs to be strong
enough so that a half of the rated max flow is kept running at all times.
• Do not connect the pump to any AC voltage power supply. It is only to be supplied with DC power
within the voltage range stated in the specification table.
• The solar panel is made with glass components. Do not drop strike or crush the solar panel. It will
break. The solar module should only be cleaned with soft tissue or glass cleaning solutions.
• It is recommended that we should not to select a pump that is too small for the Job required. If in
doubt select a bigger model.
INSTALLATION
The solar pump is designed for outdoor or indoor fountain use, and is powered by a solar panel. In order
to make the pump work by solar energy, the solar panel needs to be placed in direct sunlight with its
solar cells facing the sun as much as possible. The performance of the pump depends on the sunlight
intensity and the incident angle at which sunlight strikes the panel surface.
The pump has the build-in function of dry-run protection. The dry-run protection function is provided by
two sensor points on one side of the pump housing (referring Diagram). The pump works if both of the
points are submerged in water. If either or both points emerge out of water, the pump stops working.
The motor unit of the pump is
encapsulated with epoxy resin and
does not need lubrication. Regular
inspections, cleaning and maintenance
of impellor is necessary to ensure
longer life.
In the centre of the impellor you
may notice a small hole opening that
protrudes through the ceramic shaft
from front to back. It is paramount
that this portal is kept unblocked at
all times. This is a cooling channel for
the motor.
The pump flow rate can be adjusted
by the flow valve on the front of the
pump.
AP300_960_1360 Instructions.indd 4
A Q U A T E C E Q U I P M E N T . C O M
31/5/18 12:25 pm