HP 1405-8G Посібник зі встановлення та початку роботи - Сторінка 23

Переглянути онлайн або завантажити pdf Посібник зі встановлення та початку роботи для Перемикач HP 1405-8G. HP 1405-8G 44 сторінки. 1405 switch series
Також для HP 1405-8G: Посібник із швидкого старту (16 сторінок), Посібник зі встановлення та початку роботи (45 сторінок)

C a u t i o n

Use only the AC/DC power adapter and power cord (if applicable), supplied

with the switch. Use of other adapters or power cords, including those that

came with other HP networking products, may result in damage to the

equipment.

5. Connect the Network Cables

Connect the network cables, described under "Cabling Infrastructure"

2-5), from the network devices or your patch panels to the fixed RJ-45 ports

on the switch.

To connect:

Push the RJ-45 plug into the RJ-45

port until the tab on the plug clicks

into place. When power is on for

the switch and for the connected

device, the Link/Act LED for the

port should light to confirm a

powered-on device (for example,

an end node) is at the other end of

the cable.

If the Link/Act LED does not go on

when the network cable is

connected to the port, see

"Diagnosing with the LEDs"

chapter 4, "Troubleshooting".

To disconnect:

Press the small tab on the plug and

pull the plug out of the port.

RJ-45 connector

Unshielded twisted-pair cable:

• Category 3, 4, or 5 for 10 Mbps ports

• Category 5 or better for 100 Mbps ports

• Category 5e or better for 1000 Mbps ports

Maximum distance: 100 meters

Figure 2-6. Connecting network cables

Installing the Switch

Installation Procedures

(page

2-12