AQUATECH EDGE Pro Fuji X-T5 Інструкція з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Аксесуари для фотоапаратів AQUATECH EDGE Pro Fuji X-T5. AQUATECH EDGE Pro Fuji X-T5 9 сторінок.

Друкувати сторінку

•

You can add a little bit of grease to the end of a

toothpick and apply it to the shafts of the controls.

Once applied work in the grease by pushing the

controls and pushing the zoom shafts in and out.

(Pictures will be shown)

•

Remember a little goes a long way.

Lens Port

Before installing your Lens Port make sure the Front

Port Seal is present. Then place your port inside the

front housing and turn clockwise until it's secure.

Remember to seal your Lens Port very tight with both

hands to ensure a good seal on the front Seal

between your Lens Port and Water Housing.

Securing the Housing

When you first receive your gear we recommend that

you perform these steps without the camera and

lens inside the Water Housing:

1. Remove your back plate and port. Ensure Seals are

present and in the assigned grooves.

2.Attach the Camera Plate to the bottom of your

camera and slide it into the Sport Housings Manny

Mount.

3.With the Water Housing facing downward put your

Backplate on following the same steps detailed in the

Initial Setup.

Once the buttons are positioned over the

cameras controls correctly you can then clamp down

the two clips, making sure the two clips are firmly

locked.

5. Check the Main Seal to ensure that you have a nice

seal all around and that nothing is interfering with it.

6. You will notice a Flap on the clip when it is clamped

down. If the clip is not clamped down correctly that flap

will not be noticeable. The important final check with

the clip is to pull up against it to make sure it does not

come undone and is locked. When the Safety Clip is

locked the clip will not release and you will see a green

indicator.

7. Screw your Lens Port onto the Water Housing. Your

Port should screw on with ease and never feel as if it

is being forced. Ensure the thread on the base of your

Port and the Front of the housing are aligned. Tighten

the port clockwise making sure not to pinch the Seal.

Before every use please repeat these steps to make

sure your Water Housing has a watertight seal.

Water Testing

Water testing is a very important process before

entering the water in all types of conditions, and should

be performed before every use. Once you have followed

"Securing The Housing" instructions we recommend

that you perform a water test yourself without the

camera and lens inside.

1. Fill up a bathtub, use a swimming pool or hop in the

ocean to test. The choice is yours just as long as you

have a body of water where you can fully submerge

your equipment.

2.Hold your equipment under the water for 5-10

seconds while also pressing all the buttons. Then hold

the Water Housing above your head at a tilted angle

so that if there is any water inside it will gather at the