AQUATECH REFLEX Інструкція з експлуатації - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Аксесуари для фотоапаратів AQUATECH REFLEX. AQUATECH REFLEX 9 сторінок. Sport housing
Також для AQUATECH REFLEX: Інструкція з експлуатації (5 сторінок)
Друкувати сторінку
Initial Setup
•
After removing your Sport Housing from the box,
place it face down on a soft level surface.
•
Proceed to unlock the safety clips one by one
by pressing the safety latch forward (when the
Backplate is facing up), and pulling the clip up to
release it from the body of the housing. Now repeat
the process with the second clip, and open the
Backplate.
•
Do a quick inspection of the inside of the Sport
Housing to ensure the Camera Plate and Cable
Release are installed and ready for use.
•
Next, inspect your backplate. The main camera
controls are located here. The push button controls
are adjustable to suit the camera by winding out the
black tips on the inside of the Backplate . You can
increase or decrease sensitivity this way. Keeping
the Backplate clean will also help when reviewing
images.
•
To close your backplate push it firmly against the
body of Sport Housing making sure the safety
clips are raised up and out of the way. Place your
safety clips over the Backplate Hooks and push the
clips forward locking the Backplate securely to the
housing. Double check to make sure your two clips
are secure and locked.
Installing your Camera Plate
•
When receiving your AquaTech Sport Housing
remove the Camera Plate from the mount by sliding
the Camera Plate towards you.
•
Double check the Camera Plate is correct and
includes a 1/4"-20 screw. Each Camera Plate has the
camera model it suits engraved on the top side. To
install the Camera Plate on your Sport Housing you
will need a flat head screwdriver.
•
Lineup the top side of the Camera Plate to the
bottom of your camera ensuring the screw hole
opening on the Camera Plate is lined up with the
tripod mount thread under the camera body.
•
Screw in the Camera Plate Bolt and tighten it to the
right until you feel some resistance, be careful not to
over tighten the bolt.
Installing the Cable Release
•
Inside the Sport Housing you will find a Cable
Release connected to a PCB board on the left hand
side. Be sure the Cable Release is fully plugged into
the female end on the PCB board. The male end of
the Cable Release will be plugged into the remote
control input on your camera. Each camera has a
different spot for this input, most times you will find
this input on the left hand side of the camera.
•
Ensure the Cable Release is fully plugged into the
camera. This will now enable the electronic shutter
buttons and pistol to activate your camera shutter
to focus/fire or start/stop video.
What the Grease is used for:
The main purpose for the grease provided is to keep
the controls and shafts on your Sport Housing working
nice and smooth
4