AQUATECH LSM Інструкція з експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Перемикач AQUATECH LSM. AQUATECH LSM 12 сторінок. Level switch

GENERAL DESCRIPTION

The LSM Range units offer an easy solution to many water level control and alarm functions.

They can be used either with conductive probes in suitable conductive fluids or, with float switches in non

conductive fluids.

They have been used for emptying, filling, or level warnings within storage tanks (i.e. low or high

level) amongst many other applications, of which, some are shown within this instruction manual.

The LSM-P series come assembled with sleeved 4mm diameter 303 stainless steel probes, at a length of 1

metre, which can be cut to suit most tanks.

In applications where it is not possible to make use of the integral probes, model LSM is available, allowing

wall mounting of the unit remote from the tank/pit and using up to 4 remote probes which can be up to 15

metres from the control unit.

Units are supplied in a weatherproof case to IP55 Standard BS5490 (1977) with two glands, which accept

cables from 6 to 8 mm in diameter, other sizes on request.

Supply voltage: Standard 240V AC 50HZ 1Ø, from an isolating switch and 2 Amp fuse - NOT SUPPLIED.

LSM

- XX - X

example of a LSM unit (no integral probes)

- XXX

Aquatech-Pressmain Limited Instruction manual\Liquid Level Switch LSM

A = Single volt free Relay (R1)

B = Twin volt free relays (R1 & R2)

Blank = no integral probes

P3 = 3 off integral M4 probes

P6 = 6 off M4 probe unit (separate item)

TT = Twin tank no probes

TL = As LSM control with addition of audible alarm

Level Switch Microprocessor Controlled

24 = 24VAC or DC components

240 = 240VAC components

Remote audible/visual alarm unit powered from alarm relay of LSM unit

RA240 remote audible/visual alarm

Level Switch LSM