aQuatell Fleck 5600SXT Інструкція з експлуатації - Сторінка 14

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Диспенсер для води aQuatell Fleck 5600SXT. aQuatell Fleck 5600SXT 15 сторінок.

15. You should now see "RT" in the top left of the screen. Use the UP and DOWN buttons to set

the time of day that will be used for regeneration. Typically a time of low water demand is

selected – often 2:00 AM. Once the desired time is set, press EXTRA CYCLE

16. You should now see "BW" in the top left of the screen. Set this to "10" and then press

EXTRA CYCLE

17. You should now see "BD" in the top left of the screen. Set this to "60" and then press

EXTRA CYCLE

18. You should now see "RR" in the top left of the screen. Set this to "10" and then press

EXTRA CYCLE

19. You should now see "BF" in the top left of the screen. This value needs to be set depending

on the size of softener you ordered. You must match the value used in this step to the value

used in step 9. For instance, if you used the Salt Efficiency value in step 9 you must use the

Salt Efficiency setting from this chart for this step. Use the following chart to determine the

value to input for this stage:

Softener Type

24,000 Grain (3/4 cubic foot)

32,000 Grain (1 cubic foot)

48,000 Grain (1.5 cubic foot)

64,000 Grain (2 cubic foot)

80,000 Grain (2.5 cubic foot)

96,000 Grain (3 cubic foot)

20. Once this value has been entered press EXTRA CYCLE to advance to the next stage.

21. You should now see "FM" displayed in the top left of the screen. Use the UP or DOWN

button until "t0.7" is displayed in the center of the screen, and then press NEXT CYCLE.

You have now completed programming your Fleck 5600SXT valve.

22. You will now run a regeneration cycle while you are present to watch for leaks. Begin the

regeneration cycle by pressing and holding the NEXT CYCLE button until you hear the

gears turn.

Value to use for

Salt

Efﬁciency

Method

Page 14

Fleck 5600SXT U.S. V1.1

Value to use for

Max

Capacity

Method