aQuatell Fleck 5600SXT Інструкція з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Диспенсер для води aQuatell Fleck 5600SXT. aQuatell Fleck 5600SXT 15 сторінок.
Putting it all together - Attaching the Brine Line to the Brine Tank
The brine line (thin black plastic tubing) connects the water softener to the brine tank. At
different stages of the softener regeneration process it carries brine solution from the brine tank
to the softener and it also carries fresh water from the softener to the brine tank. This tubing
needs to be attached to the brine tank and the softener.
In a previous step you unscrewed the hex nut of the overflow assembly and set aside the tube
insert. Install the tube insert on one end of the brine line and then install this on the overflow
assembly as pictured below:
push
To attach the brine line to the brine tank you will first insert the tube insert into one end of the
brine line. Be sure to push it all the way in. Then pass this end of the brine line through the
upper hole in the brine tank and through into the brine well. Slide the hex nut onto the brine line
and then insert the brine line fully into the threaded elbow of the brine float. Now tighten down
the hex nut until it is snug making sure that the brine line is held firmly in place.
If the float assembly did not come with a tube insert, but instead has two small plastic rings,
place the plastic rings on the brine line instead of the tube insert. All other steps are the same.
Page 7
Fleck 5600SXT U.S. V1.1
Copyright aQuatell Inc 2010