Diamond Products MASONRY CC515M-E1 Посібник оператора - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник оператора для Пила. Diamond Products MASONRY CC515M-E1. Diamond Products MASONRY CC515M-E1 7 сторінок. Core cut masonry saw
Друкувати сторінку5. Ensure that extension cord gauge matches its length, as shown in chart. Undersize
extension cords may damage motor. Whenever possible, use 230 volts. Inspect
cord for cuts, knicks, or exposed wires. Replace cord if damaged.
6. If you experience any problems with your electric motor or gas engine, contact
Diamond Products for the nearest Authorized Service Center. If motor or engine is
serviced by an unauthorized service center, the warranty will be voided.
7. When transporting saw, remove cutting head from frame. Vibration during transport
could cause the cutting head to pound in the frame, causing the head to come out of
alignment. Always remove the blade when transporting.
8. Make sure that V-belts are always tensioned properly. Replace worn belts in sets.
9. Slots in cutting head are provided to keep blade aligned horizontally and vertically
with cut line on conveyor cart. Loosen lock nuts on blade shaft bearings and tilt shaft
towards appropriate direction. Tighten lock nuts when blade is properly aligned with
conveyor cart.
10. Blade should mount snugly on arbor. If blade fits loosely on arbor, or if arbor
shoulder is grooved, the inner flange must be replaced. Otherwise, blade life will be
shortened dramatically.
11. Blade flanges must have minimum outside diameter of 3 7/8". Replace worn flanges
immediately because they can shorten blade life or cause blade to break.
12. Frequently inspect conveyor cart. Replace wood insert and wheels often.
13. Replace bronze bearing in blade guard pivot plate if blade guard does not pivot
properly.
14. Clean air cleaner daily on saws with gas engine. See engine manual for
maintenance instructions.
15. For additional engine care, see engine manual.
ABOUT DIAMOND BLADES
Diamond Products manufactures diamond blades suited for your specific cutting needs -
brick, concrete block, tile, refractory etc. Contact a Diamond Products Customer Service
Representative to help determine what blade is right for your specific needs
at 1-800-321-5336 or 1-800-421-3157.