Panasonic et-jpc100be Інструкція з монтажу Посібник з монтажу - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Проектор Panasonic et-jpc100be. Panasonic et-jpc100be 28 сторінок.
Друкувати сторінкуInstallation precautions
Install this product in a place that is strong enough to withstand the weight of both the projector and
product.
Install this product in a place where the intake and exhaust of the projector will not be blocked.
Do not install this product in a place near the sea or where corrosive gas is generated.
Do not install this product in places subject to sudden temperature changes, such as near an air con-
ditioner air outlet or lighting equipment (studio lamps, etc.).
Before performing the work, be sure to shut off the power supply to the room by, for example, turning
off the wiring circuit breaker.
This product must be installed in accordance with the applicable installation code by a qualifi ed per-
sonnel, familiar with the construction and operation of the product and hazards involved.
Single copper wires with a diameter of 1.6 mm (1/16ʺ) to 2.0 mm (5/64ʺ) can be used (are supported)
for the indoor wires that connect to the terminal block of the ceiling mount bracket.
If wallpaper is affi xed to the surface where the product will be mounted to the ceiling, make sure the
wallpaper paste is suffi ciently dry before installing this product.
Failing to do so may result in rusting or discoloration of the paint.
The inrush current for the projectors supported by this product is 70 A (when power supply voltage of
100 V) to 100 A (when power supply voltage of 240 V).
Give consideration to the specifi cations of any wiring equipment that will be connected, including the wiring
circuit breaker and switches, before carrying out the wiring work.
With the exception of wood screws, use the following tightening torques for the screws and bolts.
When tightening screws or bolts, use a torque driver or torque wrench. Do not use electrical drivers
or impact drivers.
Size
Tightening torque
M4
M10
1.2 ±0.3 N•m
20 ±1 N•m
ENGLISH - 5