Panasonic PT-CW230 Інформація - Сторінка 4

Переглянути онлайн або завантажити pdf Інформація для Проектор Panasonic PT-CW230. Panasonic PT-CW230 4 сторінки. Pt-cw230 series ultra-short throw 1-chip dlp projectors

Друкувати сторінку

Speciﬁ cations

Model

Power supply

Power consumption

350 W (0.45 W when STANDBY MODE set to ECO,*

Panel size

16.5 mm (0.65 inches) (16:10 aspect ratio)

DLP™

Display method

chip

Pixels

Lens

Lamp

Screen size (diagonal)

1.52 – 2.79 m (60 – 110 inches) (16:10 aspect ratio)

Color reproducibility

Brightness*³

Center-to-corner uniformity*³

Contrast*³

1,280 × 800 pixels (Input signals that exceed this

Resolution

resolution will be converted to 1,280 × 800 pixels.)

HDMI

RGB (analog)

Scanning

frequency

(YC

)

Video/S-Video

Keystone correction range

Installation

Built-in speaker

HDMI IN

COMPUTER IN 1

COMPUTER IN 2 /

MONITOR OUT

VIDEO IN

S-VIDEO IN

Terminals

COMPUTER AUDIO IN

AUDIO IN

AUDIO OUT

SERIAL IN

LAN

(RJ-45) × 1 (for network connection, 100BASE-TX/10BASE-T, compliant with PJLink™ (class 1))

3D SYNC OUT

Cord length

Cabinet materials

Dimensions (W × H × D)

Weight

Noise level

Operating environment

Supplied accessories

Wireless remote control unit x 1, Batteries (AAA type x 2) ,Computer cable (1.8 m, for VGA) x 1

Optional accessories

Ceiling mount

bracket

for high ceilings*

for low ceilings*

ET-PKV100H

ET-PKV100S

Bracket assembly

ET-PKC100B

Caution

Do not install the projector in locations that are subject to excessive water, humidity, steam or oily smoke. Doing so may result in ﬁ re, malfunction or electric shock.

NOTE ON USE

1 The projector uses a high-voltage mercury lamp under high internal pressure. This lamp may break, emitting a popping

sound, or fail to illuminate, due to impact or extended use.

2 The high-wattage lamp becomes very hot during operation. Please observe the following precautions:

• Never place objects on top of the projector while it is in operation.

• Make sure there is an unobstructed space of 500 mm (19-11/16 in) or more around the projector's exhaust openings.

• If stacking projector units, care must be taken to provide the recommended space between units. These space

requirements also apply to installation where only one projector unit is operating at one time and the other unit is used

as a backup.

Weights and dimensions shown are approximate. Speciﬁ cations and appearance are subject to change without notice.

Product availability differs depending on region and country. This product may be subject to export control regulations.

The projection distances and throw ratios given in this brochure are for use only as guidelines. For more detailed information, please

consult the dealer from whom you are purchasing the product. The PJLink trademark is an application trademark in Japan, the

United States, and other countries and regions or registered trademarks.

Microsoft

, Windows

and Windows Vista

States and/or other countries. DLP™ (Digital Light Processing), DLP™ Chip, DLP Medallion Logo and DLP

or registered trademarks of Texas Instruments. NVIDIA™, NVIDIA™ Logo and 3D Vision™ are trademarks or registered trademarks

of NVIDIA Corporation in the United States and/or other countries. All other trademarks are the property of their respective

trademark owners. Projection images simulated.

PT-CW230

100 – 240 V AC, 50/60 Hz

DLP™ chip x 1

1,024,000 (1,280 x 800) pixels

Fixed/manual focus F = 2.5 f = 4.83 mm

275 W UHM lamp (The lamp replacement cycle is 3,000 hours*

Full color (16.77 million colors)

2500 lm

80%

2000:1 (full on/off)

(Horizontal) 15–93 kHz; (Vertical) 50–120 Hz; (Dot clock) 150 MHz or lower

(Signals exceeding the dot clock rate of 150MHz are downsampled.)

: 15.75 kHz, f

: 60 Hz [480i(525i)]

: 31.50 kHz, f

: 60 Hz [480p(525p)]

: 45.00 kHz, f

: 60 Hz [720(750)/60p]

: 33.75 kHz, f

: 60 Hz [1080(1125)/60i]

(fH) 15.75/15.63 kHz (fV) 50/60 Hz [NTSC/NTSC4.43/PAL/PAL60/PAL-N/PAL-M/SECAM]

Vertical: ± 5°

Ceiling/ﬂ oor, front/rear (Menu setting)

3.7 cm Round shape x1 output power 10 W (Monaural)

(HDMI 19-pin) x 1 (compatible with HDCP)

Audio signal Linear PCM (Sampling frequency: 48 kHz/44.1 kHz/32 kHz)

D-sub HD 15-pin (female) x 1 [RGB/YP

D-sub HD 15-pin (female) x 1 (RGB x 1) (input/output selectable using on-screen Menu)

(When Monitor Out is selected, the COMPUTER IN 1 signal is output.)

RCA pin × 1

Mini DIN 4-pin × 1

M3 x 2 (L-R x 1)

RCA pin x 2 (L-R x 1) for VIDEO/S-VIDEO input

M3 x 1 (L-R x 1)

D-sub 9-pin (female) × 1 for external control (RS-232C compliant)

Mini DIN 3-pin x 1 (for 3D transmitter connection)

3.0 m (9'10")

Molded plastic (PC)

321 x 178 x 386 mm (12-5/8" × 7" × 15-3/16") (with legs at shortest position)

Approx.6.2 kg (13.7 lbs)*

36 dB (Lamp power: Normal); 28 dB (Lamp power: Eco)

Operating temperature: 0° – 40°C(32° – 104°F) (Less than 1000 m above sea level);

0° – 30°C(32° – 86°F) (1000 – 2700 m above sea level)

Operating humidity: 20% - 80% (no condensation)

Power cord x 1( x 2 for PT-CW230EA, PT-CX200EA), Power cord cover x 1,

Wall mount bracket

ET-PKC100W

are either registered trademarks or trademarks of Microsoft Corporation in the United

PT-CX200

11.0 W when STANDBY MODE set to NETWORK.)

14 mm (0.55 inches) (4:3 aspect ratio)

DLP™ system

786,432 (1,024 x 768) pixels

)

1.40 – 2.29 m (55 - 90 inch) (4:3 aspect ratio)

2000 lm

1,024 × 768 pixels (Input signals that exceed this

resolution will be converted to 1,024 × 768 pixels.)

: 15.63 kHz, f

: 50 Hz [576i(625i)]

: 31.25 kHz, f

: 50 Hz [576p(625p)]

: 37.50 kHz, f

: 50 Hz [720(750)/50p]

: 28.13 kHz, f

: 50 Hz [1080(1125)/50i]

)/P

) x 1]

Replacement lamp unit

Replacement filter unit

ET-LAC100

ET-RFC100

• If the projector is placed in a box or enclosure, the temperature of the air surrounding the projector must match the

operating temperature listed in the speciﬁ cations table during use. Also, make sure the projector's intake and exhaust

openings are not blocked. Ensure there is sufﬁ cient ventilation to prevent hot air from the exhaust openings being

recirculated into the intake opening.

3 The lamp replacement cycle duration becomes shorter if the projector is operated repeatedly for short periods.

• The lamp replacement cycle varies greatly depending on individual lamp characteristics and usage conditions.

• The brightness of the lamp will gradually decrease with use.

4 Due to natural characteristics of lamps, screen brightness may ﬂ uctuate. This is not an indication of faulty lamp performance.

Link™ are trademarks

Projection distance

Projected image

PT-CW230 (16:10 aspect ratio; throw ratio: 0.19:1)

Distance from

the edge of

Diagonal

the projector

the projection

image size

front to the

window to the

screen (B)

screen (A)

1.52 [60"] 0.23 (0.75') -0.07 (-0.23') 0.05 (0.16') 0.23 (0.75')

(0.92') -0.02 (-0.07')

1.78

[70"]

0.28

(1.05') 0.02 (0.07')

2.03

[80"]

0.32

(1.21') 0.07 (0.23') 0.11 (0.36') 0.29 (0.95')

2.29

[90"]

0.37

(1.35')

(0.36')

2.54

[100"]

0.41

0.11

(1.51')

(0.52')

2.79

[110"]

0.46

0.16

PT-CX200 (4:3 aspect ratio; throw ratio: 0.24:1)

Distance from

the edge of

Diagonal

the projector

the projection

image size

front to the

window to the

screen (B)

screen (A)

1.40 [55"] 0.25 (0.82') -0.05 (-0.16') 0.07 (0.23') 0.25 (0.82')

(0.92') -0.02 (-0.07')

1.52

[60"]

0.28

(1.08') 0.04 (0.13')

1.78

[70"]

0.33

(1.25') 0.09 (0.30') 0.14 (0.46') 0.32 (1.05')

2.03

[80"]

0.38

(1.44')

(0.46')

2.29

[90"]

0.44

0.14

Dimensions

321(12-5/8)

*1 When Standby mode is set to Eco, network functions such as

standby on via LAN are not available. Only certain commands

can be received for external control using the serial terminal.

*2 This is the maximum value when the lamp power is set to

Eco mode where the lamp is turned on for 2 hours and off

for 0.25 hours. If the lamp is turned on more times or kept

on for a long time, the lamp replacement cycle will shorten.

In Normal mode, the lamp replacement cycle is 2,000 hours.

The usage environment affects the duration of the lamp.

*3 Measurement, measuring conditions, and method of

notation all comply with ISO 21118 international standards.

*4 The above values are averages. Actual values may be

different according to the product.

*5 This product is used together with an optional bracket

assembly (sold separately).

For more information about Panasonic projectors

http://panasonic.net/avc/projector

All information included here is valid as of March 2012.

PT-CW230G1 Printed in Japan.

unit: meters (feet)

Height from

the edge of

the edge of the

the screen to

screen to the

the top of the

bottom of the

projector (E)

projector (F)

(0.23')

(0.82')

0.07

0.25

(0.30')

(0.89')

0.09

0.27

(0.43')

(1.02')

0.13

0.31

(0.49')

(1.08')

0.15

0.33

Height from

the edge of

the edge of the

the screen to

screen to the

the top of the

bottom of the

projector (E)

projector (F)

(0.30')

(0.89')

0.09

0.27

(0.36')

(0.95')

0.11

0.29

(0.56')

(1.15')

0.17

0.35

unit: mm (inch)

386(15-3/16)