Panasonic PT-DX500U Посібник з експлуатації мережі - Сторінка 14
Переглянути онлайн або завантажити pdf Посібник з експлуатації мережі для Проектор Panasonic PT-DX500U. Panasonic PT-DX500U 42 сторінки. Dlp based projector
Також для Panasonic PT-DX500U: Технічні характеристики (4 сторінок)
Друкувати сторінку
NETWORK menu (continued)
●
AUTHENTICATION
OPEN
SHARED
WPA-PSK
_
2
WPA2-PSK
_
2
●
ENCRYPTION
NONE
WEP
_
1
TKIP
_
1
AES
_
1
1: "Glossary" (
See page 40 – 41)
_
2: Available when the mode is set to [INFRASTRUCTURE].
_
Press [NEXT] after configuration is completed. Select [NEXT] if [WEP] is selected as the encryption method, and
select [STORE] if [OPEN] is selected. At this point, select [RETURN] to go back to the previous screen (1/2), or
select [CANCEL] to cancel the configuration change.
Note
・
IEEE802.1x is not supported.
・
Important video/audio data is protected because AES encryption processing takes place in advance for all
network numbers, even if [ENCRYPTION] is set to [NONE].
If [WEP] is selected as the encryption method, then perform the additional configuration below.
WIRELESS LAN
DEFAULT KEY
1
KEY1
KEY2
KEY3
KEY4
RETURN
STORE
CANCEL
MENU SELECT
CHANGE
●
When setting [OPEN] or [SHARED] as authentication and setting [WEP] as the encryption
method:
DEFAULT KEY
KEY1 – 4
●
When using [WPA-PSK] or [WPA2-PSK] : Set key and select [OK].
Note
・
If you are unable to connect to the wireless LAN through the access point even after performing the steps in
"Projector settings (See page 19)", contact the manufacturer of the access point.
：Set the user authentication method used by the network to be connected.
：Select when making a connection using [AD HOC], or when the access point
authentication method is OpenSystem
：Select when making a connection using [AD HOC], or when the access point
authentication method is Shared Key
：Select when the access point authentication method is WPA-PSK
：Select when the access point authentication method is WPA2-PSK
：Select the encryption method to be used for communication between the
projector and the network.
：Select when transmit without encryption. It is selectable only when
[AUTHENTICATION] is [OPEN] or [SHARED].
：Select when ENCRYPTION is WEP.
：Select when ENCRYPTION is TKIP.
Selectable when [AUTHENTICATION] is either [WPA-PSK] or [WPA2-PSK].
：Select when ENCRYPTION is AES.
Selectable when [AUTHENTICATION] is either [WPA-PSK] or [WPA2-PSK].
3/3
：Set 1 – 4 numerals for the default key.
：Set these to match the WEP key registered in [DEFAULT KEY] and select [OK].
Either the 64-bit or 128-bit WEP key can be set. For the 64-bit key, input five
alphanumerics (or a 10-digit string for the hexadecimal format) for the 128-bit key,
input 13 alphanumerics (or a 26-digit string for the hexadecimal format).
Input either 8 to 63 alphanumerics or a 64 digit string in the hexadecimal format.
.
_
1
.
_
1
14
.
_
1
.
_
1