Panasonic PT-DZ6700E Інструкція з експлуатації Посібник з експлуатації - Сторінка 30
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Проектор Panasonic PT-DZ6700E. Panasonic PT-DZ6700E 42 сторінки. Brochure
Також для Panasonic PT-DZ6700E: Брошура та технічні характеристики (6 сторінок), Брошура та технічні характеристики (6 сторінок)
Replacement
Replacing the Lamp unit
Before replacing the Lamp unit
T
urn off the
POWER
Wait for more than 1 hour and make sure the lamp unit and the surroundings are cooled enough.
Prepare a Phillips-head screwdriver.
Contact the dealer to purchase a replacement lamp unit (ET-LAD60:1 bulb unit, ET-LAD60W: 2 bulb units).
When the projector is mounted on the ceiling, do not work directly under the projector or put your face
closer to the projector.
CAUTION:
• The lamp may explode by shocks or chipping damage.
NOTE:
• Prior to replacing the lamp unit, allow it to cool down to prevent the risk of burns, damage and other hazards.
• Do not attempt replacement with an unauthorised lamp unit.
• Both lamps must be set in a lamp unit. If only one lamp is set, the power will not work.
When to replace the lamp unit
The lamp unit is consumable and the brightness decreases by duration of usage. The LAMP1/LAMP2
indicators will inform you of the replacement timing at 1 800
turned off. Those figures are rough guidance and might be shortened by the usage conditions, characteristics
of the lamp unit, environmental conditions, and so on. You can check the duration of usage time using LAMP1
STATUS in the PROJECTOR SETUP menu.
of
LAMP2
Indication
*2
Over 1 800
hours
*1
Over 2 000
hours
CAUTION:
• If you keep using the lamp unit after 2 000
after 10 minutes.
NOTE:
• The guide times, 1 800
• For more information about the lamp unit, see the instructions which is provided with the lamp unit.
*1. 3 000 hours for PT-D5000E.
*2. 2 800 hours for PT-D5000E.
E
NGLISH - 30
switch of the projector in proper way
On screen
REPLACE LAMP
"REPLACE LAMP" is displayed on the upper left
of the screen for 30 seconds. Press any button to
clear the screen, or disappears after 30 seconds.
"REPLACE LAMP" is displayed on the upper left
of the screen, and it will stay until you respond.
To clear the screen, press any button.
*1
hours, it cause the damage of the projector. Automatically the projector will be powered off
*2
*1
and 2 000
hours, are rough estimates based on certain conditions and are not a guaranteed time.
and disconnect the mains plug from the mains socket.
*2
*1
hours, and at 2 000
LAMP indicator
Lights in red
hours, the projector will be
LAMP
LAMP
/