Panasonic PT-DZ870 Технічні характеристики - Сторінка 7
Переглянути онлайн або завантажити pdf Технічні характеристики для Проектор Panasonic PT-DZ870. Panasonic PT-DZ870 8 сторінок. Pt-dz870 series 1-chip dlp projectors
Друкувати сторінку
Specifications
Model
Power supply
Power consumption
Dissipation BTU
DLP
chip
Panel size
™
Display method
Pixels
Lens
PT-DZ870/DW830/DX100
PT-DZ870L/DW830L/DX100L
Lamp
Screen size (diagonal)
Brightness*
2
Center-to-corner uniformity*
2
Contrast*
2
Resolution
Scanning frequency
SDI
3G-SDI
HD-SDI
SD-SDI
HDMI/DVI-D
RGB
YP
P
(YC
C
)
B
R
B
R
Video/YC
Optical axis shift*
3
Keystone correction range
Keystone correction range with the
optional upgrade kit ET-UK20
Installation
Terminals
SDI IN
HDMI IN
DVI-D IN
RGB 1 IN
RGB 2 IN
3D SYNC 1 IN/OUT
3D SYNC 2 OUT
VIDEO IN
SERIAL IN
SERIAL OUT
REMOTE 1 IN
REMOTE 1 OUT
REMOTE 2 IN
LAN / DIGITAL LINK
Cabinet materials
Dimensions (W × H × D)
PT-DZ870/DW830/DX100
PT-DZ870L/DW830L/DX100L
Weight*
14
PT-DZ870/DW830/DX100
PT-DZ870L/DW830L/DX100L
Operation noise
Operating environment*
2
Supplied accessories
* 1 When the
is set to
, network functions such as power on over the LAN will not operate. Also, only certain commands can be received
S TA N D B Y M O D E
E C O
for external control using the serial terminal. * 2 Measurement, measuring conditions, and method of notation all comply with ISO 21118 international
standards. * 3 Optical axis shift cannot be operated with the ET-DLE055. * 4 +45% with the ET-DLE085. * 5 ±30° with the ET-DLE085/DLE055 and
+5° with the ET-DLE030. * 6 ±20° (±8° with the ET-DLE085/DLE055) when using both the
ment function. * 7 When using the
KEYSTONE
corrections of the Geometric Adjustment function. * 9 Not operable with the ET-DLE030. * 10 Up to a total of ±55°
both the
KEYSTONE
and
CURVED
during simultaneous horizontal and vertical correction. * 11 ±40° with the ET-DLE150/DLE250/supplied lens, ±22° with the ET-DLE085/DLE055 and
+5° with the ET-DLE030. * 12 ±15° with the ET-DLE085/DLE055 (±8° when using both the
ment function). * 13 With legs at shortest position. * 14 Average value. May differ depending on models. * 15 The operating temperature range is 0 °C to 40 °C (32 °F to 104 °F) when the fan control
is set to High Altitude mode (for altitudes from 1,400 m to 2,700 m (4,593 ft to 8,858 ft) above sea level). Also, if the ambient temperature exceeds 40 °C (104 °F) (35 °C (95 °F) in High Altitude
mode) when the projector is being used with Lamp Select set to Dual and Lamp Power set to High, the light output may be reduced approximately 20% to protect the projector.
N O T E S O N U S E
1. Do not install the projector in locations that are subject to excessive water, humidity, steam, or oily
smoke. Doing so may result in fire, malfunction, or electric shock.
2. The projector uses a high-voltage mercury lamp that contains high internal pressure. This lamp may
break, emitting a loud sound, or fail to illuminate, due to impact or extended use.
3. The projector uses a high-wattage lamp that becomes very hot during operation. Please observe the fol-
lowing precautions:
tor's exhaust openings.
jection. When stacking projector units, be sure to provide the amount of space indicated between
them. These space requirements also apply to installation where only one projector unit is operating at
one time and the other unit is used as a backup.
be between 0 °C ( 32 °F ) and 40 °C (104 °F ). Also make sure the projector's intake and exhaust
openings are not blocked. Take particular care to ensure that hot air from the exhaust openings is not
PT-DZ870/DZ870L
120−240 V AC, 10–5.2 A, 50/60 Hz
1,030 W (1,060 VA)(0.3 W when
set to
STANDBY MODE
3,516 BTU/hour (without light: 3,400 BTU/hour for the PT-DZ870/DZ870L/DW830/DW830L, 3,379 BTU/hour for the PT-DX100/DX100L)
17.0 mm (0.67 inches) diagonal (16:10 aspect ratio)
DLP
™
chip × 1, DLP
™
projection system
2,304,000 (1,920 × 1,200) pixels
Powered zoom (throw ratio 1.7–2.4:1),
powered focus F 1.7–1.9, f 25.6–35.7 mm
Optional powered zoom/focus lenses and fixed-focus lens
420 W UHM lamp × 2
1.27–15.24 m (50–600 in), 1.27–5.08 m (50–200 in) with the ET-DLE055, 2.54–8.89 m (100–350 in)
with the ET-DLE030, 16:10 aspect ratio
8,500 lm (dual-lamp,
:
)
LAMP MODE
NORMAL
90 %
10,000:1 (full on/full off, in dynamic iris 3 mode)
1,920 × 1,200 pixels
SMPTE ST 424 compliant, [RGB 4:4:4 12-bit/10-bit]
1125(1080)/60i, 1125(1080)/50i, 1125(1080)/25p,
1125(1080)/24p, 1125(1080)/24sF, 1125(1080)/30p,
[YP
P
4:2:2 10-bit] 1125(1080)/60p, 1125(1080)/50p
B
R
SMPTE ST 292 compliant, [YP
P
4:2:2 10-bit]
B
R
750(720)/60p, 750(720)/50p, 1125(1035)/60i,
1125(1080)/60i, 1125(1080)/50i, 1125(1080)/25p,
1125(1080)/24p, 1125(1080)/24sF, 1125(1080)/30p
SMPTE ST 259 compliant, [YC
C
4:2:2 10-bit]
B
R
525i(480i), 625i(576i)
f
: 15–100 kHz, f
: 24–120 Hz, dot clock: 25–162 MHz
H
V
: 15–100 kHz, f
: 24–120 Hz, dot clock: 162 MHz or lower
f
H
V
f
: 15.75 kHz, f
: 60 Hz [480i (525i)]
H
V
f
: 31.50 kHz, f
: 60 Hz [480p (525p)]
H
V
f
: 15.63 kHz, f
: 50 Hz [576i (625i)]
H
V
f
: 31.25 kHz, f
: 50 Hz [576p (625p)]
H
V
f
: 45.00 kHz, f
: 60 Hz [720 (750)/60p]
H
V
f
: 15.75 kHz, f
: 60 Hz [NTSC/NTSC4.43/PAL-M/PAL60], f
H
V
Vertical +50%, horizontal ±10%, powered
Vertical ±40° *
, horizontal ±15° *
5 / 6
7/8
Vertical ±45° *
10 / 11
, horizontal ±40° *
10 /12
Ceiling/floor, front/rear
BNC × 1 (3G/HD/SD-SDI)
HDMI 19-pin × 1 (Deep Color, compatible with HDCP)
DVI-D 24-pin × 1 (DVI 1.0 compliant, compatible with HDCP, compatible with single link only)
BNC × 5 (RGB/YP
P
/YC
C
/YC × 1)
B
R
B
R
D-Sub HD 15-pin (female) × 1 (RGB/YP
P
/YC
B
R
BNC × 1
BNC × 1
BNC × 1 (composite video)
D-sub 9-pin (female) × 1 for external control (RS-232C compliant)
D-sub 9-pin (male) × 1 for link control
M3 × 1 for wired remote control
M3 × 1 for link control (for wired remote control)
D-sub 9-pin (female) × 1 for external control (parallel)
RJ-45 × 1 (for network and DIGITAL LINK (video/network/serial control) connection, 100Base-TX, compatible with Art-Net, compliant with PJLink™, Deep Color,
compatible with HDCP)
Molded plastic
498 × 200*
× 556 mm (19-19/32 × 7-7/8*
13
498 × 200*
× 513 mm (19-19/32 × 7-7/8*
13
Approximately 18.3 kg (40.3 lbs) (with supplied lens)
Approximately 17.6 kg (38.8 lbs) (without lens)
40 dB (
:
), 35 dB (
:
LAMP MODE
NORMAL
LAMP MODE
ECO
Operating temperature: 0–45 °C (32–113 °F)*
Power cord with secure lock, wireless/wired remote control unit, batteries (R03/AAA type × 2), software CD-ROM (Logo Transfer Software,
Multi Projector Monitoring & Control Software)
corrections of the Geometric Adjustment function. * 8 ±15° (±8° with the ET-DLE085/DLE055) when using
PT-DW830/DW830L
*
1
, 3 W when
set to
ECO
STANDBY MODE
NORMAL
16.5 mm (0.65 inches) diagonal (16:10 aspect ratio)
DLP
™
chip × 1, DLP
™
projection system
1,024,000 (1,280 × 800) pixels
Powered zoom (throw ratio 1.8 – 2.5:1), powered focus F 1.7–1.9, f 25.6 – 35.7 mm
1,280 × 800 pixels (Input signals that exceed this
resolution will be converted to 1,280 × 800 pixels.)
–
f
: 37.50 kHz, f
: 50 Hz [720 (750)/50p]
H
V
f
: 33.75 kHz, f
: 60 Hz [1035 (1125)/60i]
H
V
f
: 33.75 kHz, f
: 60 Hz [1080 (1125)/60i]
H
V
f
: 28.13 kHz, f
: 50 Hz [1080 (1125)/50i]
H
V
f
: 28.13 kHz, f
: 25 Hz [1080 (1125)/25p]
H
V
: 15.63 kHz, f
: 50 Hz [PAL/PAL-N/SECAM]
H
V
Vertical +60%, horizontal ±10%, powered
Vertical ±40° *
9
–
–
C
× 1)
B
R
× 21-7/8 in)(with supplied lens)
13
× 20-3/16 in) (without lens)
13
)
15
, operating humidity: 10%–80% (no condensation)
and
corrections of the Geometric Adjust-
KEYSTONE
CURVED
and
corrections of the Geometric Adjust-
KEYSTONE
CURVED
sucked into the intake.
4. If the projector is to be operated continuously 24 hours a day / 7 days a week, use the multi-lamp optical
system's alternating lamp operation function ( Lamp Relay mode). The projector can be operated continuously
24 hours a day / 7 days a week in dual-lamp operation mode. Allow a minimum of two hours per week of
non-operation time per lamp if using the dual-lamp operation mode.
5. The lamp replacement cycle duration becomes shorter if the projector is operated repeatedly for short
periods.
-
individual lamp characteristics and usage conditions.
-
6. Because the E T-DLE055 / DLE030 is a fixed short-throw lens, the lens shift function cannot be used with
it.
7. Due to natural characteristics of lamps, screen brightness may vary (flicker). This is not an indication of
faulty lamp performance.
PT-DX100/DX100L
)
17.8 mm (0.7 inches) diagonal (4:3 aspect ratio)
DLP
™
chip × 1, DLP
™
projection system
786,432 (1,024 × 768) pixels
1.27–15.24 m (50 – 600 in), 1.27– 5.08 m
(50 – 200 in) with the ET-DLE055, 2.54 – 8.89 m
(100 – 350 in) with the ET-DLE030, 4:3 aspect ratio
10,000 lm (dual-lamp,
LAMP MODE
1,024 × 768 pixels (Input signals that exceed this
resolution will be converted to 1,024 × 768 pixels.)
f
: 27.00 kHz, f
: 24 Hz [1080 (1125)/24p]
H
V
f
: 27.00 kHz, f
: 48 Hz [1080 (1125)/24sF]
H
V
f
: 33.75 kHz, f
: 30 Hz [1080 (1125)/30p]
H
V
f
: 67.50 kHz, f
: 60 Hz [1080 (1125)/60p]
H
V
f
: 56.25 kHz, f
: 50 Hz [1080 (1125)/50p]
H
V
Vertical +50%*
4
, horizontal ±10%, powered
Dimensions
498
(19-19/32)
:
)
NORMAL
u n it : mm ( in ch e s )
556
(21-7/8)
6