Diamondback SE Посібник з монтажу

Переглянути онлайн або завантажити pdf Посібник з монтажу для Автомобільні аксесуари Diamondback SE. Diamondback SE 2 сторінки. Hard tonneau cover for '15–up colorado & canyon with the 61.7" cargo box
Також для Diamondback SE: Посібник з монтажу (2 сторінок), Посібник з монтажу (2 сторінок), Посібник з монтажу (2 сторінок), Посібник з монтажу (2 сторінок)

Друкувати сторінку

DiamondBackCovers.com / 800 935 4002

INSTALLATION GUIDE

45 minutes

Normal install time

PARTS INCLUDED:

Cab Panel

Center Panel

Tail Panel

PRE-INSTALLATION NOTES:

If you are installing a cab guard or headache rack, you should

mount it prior to mounting your DiamondBack cover. Refer to its

installation guide for details.

MOUNT THE PANELS

Place the center panel across the

center of the bed, cheated slightly

toward the tailgate.

Since the cover is

slightly tapered,

make sure the

arrow sticker on

the underside of

the center panel is

pointing toward

the tailgate.

Loosely aﬃx the center panel to the truck by ﬁnger-tightening a cap

clamp at each of the four interior corners of the underside of the

center panel.

Attach the tail panel by angling it 90° from the bed rails, sliding its

driver-side, loop-shaped hinge knuckle fully onto the corresponding

center-panel hinge pin, then dropping its passenger-side, C-shaped

hinge knuckle fully onto its corresponding pin.

FIRST

Keep an eye out for these icons:

Bed-Rail

Edge Trim (4)

Cap Clamps (4)

90°

IMPORTANT!

Important installation information

1/8" Hex Key

Springs (4)

It's possible for one person to install a DiamondBack solo, but the

whole process, especially positioning the panels and adjusting the

lock rods, is much easier with two people.

Lower the tail panel into the closed position.

To avoid hinge damage, make sure the drop-on hinge

is fully mated before beginning to close the panel.

Repeat steps 3–4 for the

cab panel, starting this

time with the loop-shaped

hinge knuckle on the

passenger side.

Position the cover front to back so that the

leading edge of the closed cab panel lines up with

the outside edge of the center of the bulkhead.

Center the cover side to side on

the truck.

SECOND

Tighten the cap clamps

with a 9/16" socket.

Road vibration can loosen your clamps. Retighten them after

100 miles. Check them every time you haul on top.

HD SE

TOOLS REQUIRED:

Ratchet Wrench

Gas

Utility Knife

CVR-1

Helpful Hints

Tips to assist installation

9/16"

Socket

7/16"

Socket

FULLY MATED

CONTINUED ON REVERSE >