Panasonic MW10 - 9.0" - Digital Photo frame Інструкція з експлуатації Посібник з експлуатації - Сторінка 21

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Стереосистема Panasonic MW10 - 9.0" - Digital Photo frame. Panasonic MW10 - 9.0" - Digital Photo frame 24 сторінки. Multimedia audio system
Також для Panasonic MW10 - 9.0" - Digital Photo frame: Інструкція з експлуатації Посібник з експлуатації (24 сторінок)

Друкувати сторінку

Troubleshooting guide

Before requesting service, make the following checks. If you are in doubt about some of the check points, or if the remedies

indicated in the chart do not solve the problem, refer to "Customer Services Directory (United States and Puerto Rico)" on page 23.

This unit may become hot if used for a long period of time, however, this is not a problem for use.

Common problems with the whole system

All operations are ignored.

When the unit is turned on,

"Please wait." is displayed for a

long period of time.

Booming noise occurs during

audio playback.

The display does not change even

after the CD is inserted.

Playback does not start even after

the play button is pressed.

Speciﬁ c parts are not played normally.

The display part is not closed properly.

Data on the SD card cannot be read.

Photos cannot be played or

edited.

iPod

The iPod is not recognised even if

connected.

Video playback becomes

impossible on the iPod.

The display of the iPod video

playback shows an unexpected one.

iPod videos cannot be played back.

Radio

FM and AM broadcasts cannot be

received properly.

Noise and sound distortion are

excessive.

" " does not light up.

Remote control

Cannot operate the remote

control.

Another device does not operate

properly when using the remote

control of this unit.

The unit does not operate

properly when using the remote

control of another device.

Press [POWER8] of the main unit for more than 10 seconds to turn the unit off. If the

problem persists, do the following operations and return the settings to the factory defaults.

1. Remove the AC power supply cord once. Then connect the AC power supply cord

while pressing down [POWER8] of the main unit.

2. Press and hold [POWER8] of the main unit until "The settings have been reset."

appears on the display.

When photos are present in the internal memory or the SD card has been inserted, it

may take long time for the unit to become operable after it is turned on.

There may be the AC power supply cord of another device or ﬂ uorescent light near this unit.

Keep the electric appliances as far away as possible from this unit.

A nonstandard disc was inserted. ( P4)

There was extreme temperature difference, such as when carrying the unit from the cold

place to the warm place. Dew condensation might have occurred on the lens.

Wait approx. 1 hour before use.

Wipe the CD with a soft cloth. ( P4)

Check if the CD is set at the correct position. ( P6)

Use the SD card, ﬁ le format and folder hierarchy compatible with this unit. ( P5)

Insert the SD card compatible with this unit. ( P5)

Insert the SD card correctly. ( P6)

Cancel the write protection switch if it is on the "LOCK" side. ( P4)

Check if the iPod is compatible with this unit. ( P5)

Conﬁ rm the iPod video settings.

Check your iPod version.

Connect the FM indoor antenna or AM loop antenna. ( P8)

Change the setting location or direction of antennas.

Separate the antenna wire and AC adaptor as far as possible.

If the transmitting location is far or there is a big building or mountain near the unit,

use an outdoor antenna. ( P13)

TV, VCR, PC or BS tuner may be on. Or the mobile phone may be charged near the unit.

Turn each device off or keep those devices as far away as possible from this unit.

Insert (+, –) of battery correctly. ( P7)

Replace with the new battery. ( P7)

If the remote control mode on the main unit does not match the one on the remote

control, match the mode of the remote control to the one of the main unit. ( P18)

If the display is opened, close it.

Change the remote control mode of this unit so another device does not interfere with

this unit's operation. ( P18)