Panasonic MW10 - 9.0" - Digital Photo frame Інструкція з експлуатації Посібник з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Стереосистема Panasonic MW10 - 9.0" - Digital Photo frame. Panasonic MW10 - 9.0" - Digital Photo frame 24 сторінки. Multimedia audio system
Також для Panasonic MW10 - 9.0" - Digital Photo frame: Інструкція з експлуатації Посібник з експлуатації (24 сторінок)
Друкувати сторінкуConnecting antennas and power source
1
2
F
E
1. Connect the FM indoor antenna.
•
Insert fi rmly to the end.
•
Receive broadcast signals ( P12) after connection
and fi x the end of the antenna using a tape (A) at the
least noisy position.
2. Connect the AM loop antenna.
B Insert into the groove. Insert fi rmly until it clicks.
C Red D White E Black
F Use a Phillips-head screwdriver, etc. Do not screw
too tightly. Otherwise, the screwdriver goes around in
circle and cannot be fi xed.
•
Receive broadcast signals ( P12) after connection
and place the antenna at the least noisy position.
3. Connect the AC mains lead.
For the United Kingdom only
READ THE CAUTION FOR THE AC MAINS LEAD ON
PAGE 2 BEFORE CONNECTION.
G AC adaptor
H AC mains lead
I To household mains socket (Connect last.)
Insertion of connector
Even when the connector is perfectly inserted,
depending on the type of inlet used, the front part of the
connector may jut out as shown in the drawing.
However there is no problem using the unit.
J Connector
K Appliance inlet
L Approx. 6 mm
Note
•
While using this unit, the AC adaptor may become a little
hot. This is not a malfunction.
8
A
B
C
D
J
K
L
3
H
I
G
When the Demo function ( P18) is activated
When connecting the AC
mains lead, the unit is
automatically turned on and
the screen shown at right
appears.
When not using the demo function , press [e, r] on the
remote control to select the setting to disable it, and then
press [OK].
With the demo function, simple explanations about the
unit's functions are displayed on the display part.
•
If it is set to Enable or operation is not performed for
more than 2 minutes, the demo function is activated. If
the unit is operated, the demo function is cancelled and
the standard screen appears.
•
You can switch the demo function to Enable/Disable by
pressing [DISPLAY MODE] on the main unit for approx. 2
seconds while audio is stopped.
To remove the AC mains lead
Turn the unit off.
After the screen completely turns off, pull out the AC mains
lead.
About speakers
•
These speakers do not have magnetic shielding. Do not
place them near televisions, personal computers or other
devices easily infl uenced by magnetism.
•
You can damage your speakers and shorten their useful
life if you play sound at high levels over extended periods.
•
When the sound is distorted, turn down the volume even in
the normal use. (Failure to do so may cause the speakers
to be damaged.)
•
The speaker nets cannot be removed.
Back of product
Start Demo
Disable the Demo function