Panasonic RX-ES23 Інструкція з експлуатації Посібник з експлуатації - Сторінка 10
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Стереосистема Panasonic RX-ES23. Panasonic RX-ES23 16 сторінок. Portable stereo cd system
Також для Panasonic RX-ES23: Інструкція з експлуатації Посібник з експлуатації (29 сторінок)
Друкувати сторінку
Cassette Tape Play
[1] Press [< DECK] to open the deck.
(The unit comes on.)
Load a cassette and close the
deck by hand.
A: Side to be played back facing
up.
B: Insert the cassette with the
exposed tape facing you.
[2] Press [1TAPE] to start play.
[3] Press [+, – VOLUME] to adjust volume.
To
stop play
start one touch play*
fast-forward
rewind
* when using AC power.
Cassette Tape Recording
Before Recording
Your attention is drawn to the fact that recording pre-recorded
tapes or discs or other published or broadcast material may
infringe copyright laws.
Notes:
≥
Use household AC power or new batteries when recording to
avoid poor recordings caused by the batteries running down.
≥
Televisions can cause interference to recordings made on
this unit if they are too close to each other.
Selection of tapes
Use normal position tapes.
High position and metal position tapes can be played, but the
unit will not be able to record or erase correctly.
10
RQT7912
A
B
Operations
Press [∫ TAPE/CD].
Press [1TAPE] when a cassette is
loaded.
Press [5/+/FF]. On remote
control, press [5/FF].
Press [REW/–/6].
On remote control, press
[6/REW].
TAPE ⁄ CD
Volume and sound quality in recording
≥
Recording level is set automatically.
≥
Recordings are unaffected by changes to sound quality.
To display the tape counter while recording
Press [DISPLAY].
Each time you press the button in the CD or radio mode:
n ,
#
Present state
Present time
=====
==========
]
To reset the tape counter
Press [C.RESET].
The counter resets to "000".
Erasure prevention
The illustration shows how to remove the tabs to prevent
recording. To record on the tape again, cover as shown.
A
B
C
To erase recordings
1 Press [< DECK] to open the deck and insert the cassette
with the side to be erased facing up.
2 Press [∫ TAPE/CD] to switch to TAPE mode.
3 Press [¥/;].
Recording CDs
Normal recording
Preparation:
Wind on the leader tape.
[1] Press [< DECK] to open the deck.
[2] Press [∫ TAPE/CD] to switch to CD mode.
[3] Press [¥/;] to start recording.
CD play and recording start at the same time.
The cassette stops when the CD finishes.
]
#
Tape counter
n
A Side A
B Tab for side "B"
C Tab for side "A"
D Adhesive tape
D