Panasonic SA-AK980 Інструкція з експлуатації Посібник з експлуатації - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Стереосистема Panasonic SA-AK980. Panasonic SA-AK980 24 сторінки.
Друкувати сторінку
Preparing the remote control
Use alkaline or manganese batteries.
Insert so the poles (+ and –) match those in the
remote control.
DEMO function
Handling of the disc trays and discs
Not doing the following will cause damage to the unit.
Removing the power plug
Press [y/I, POWER] to turn off the unit and remove the power plug only after all the displays have disappeared.
Inserting a disc
• Place the disc correctly with the label facing up as shown in the diagram.
• Insert one disc into each tray.
RQTX0273-2M_us.indd 5
RQTX0273-2M_us.indd 5
R6/LR6, AA
7, –DEMO
Aim at the remote control signal sensor (\ page 8), avoiding obstacles, at a
maximum range of 7 m directly in front of the unit.
Note on using the remote control
• Do not mix old and new batteries.
• Do not use different types of batteries at the same time.
• Do not take apart or short circuit the batteries.
• Do not attempt to recharge alkaline or manganese batteries.
• Do not use batteries if the covering has been peeled off.
•
Do not heat or expose to fl ame.
•
Do not leave the battery(ies) in an automobile exposed to direct sunlight
for a long period of time with doors and windows closed.
• Mishandling of batteries in the remote control can cause electrolyte
leakage, which may cause a fi re.
• Remove the batteries if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type recommended by the manufacturer. Dispose
of used batteries according to the manufacturer's instructions.
When the unit is fi rst plugged in, a demonstration of its functions may be
shown on the display.
If the demo setting is off, you can show a demonstration by selecting "DEMO
ON".
Press and hold [7, –DEMO] on the main unit.
The display changes each time you press and hold the button.
DEMO OFF (off)
DEMO ON (on)
While in standby mode, select "DEMO OFF" to reduce power consumption.
Note:
DEMO function cannot be turned on when dimmer function is on.
Tray caution
• Always press [0, OPEN/CLOSE] to insert or remove
a disc.
• Do not push or pull out the tray by hand as this will
cause an accident.
5
RQT8043
12/21/09 12:21:21 PM
12/21/09 12:21:21 PM