DIAQUIP QHS-400 Посібник оператора - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник оператора для Пила. DIAQUIP QHS-400. DIAQUIP QHS-400 18 сторінок. Electric handsaw
Друкувати сторінку
ELECTRICAL CONNECTION
The network voltage must conform to the voltage indicated on the tool name plate. Under no
circumstances should the tool be used when the power supply cable is damaged. A damaged
cable must be replaced immediately by an authorized Customer Service Center. Do not try to
repair the damaged cable yourself. The use of damaged power cables can lead to an electric
shock.
WARNING: Never operate a damaged machine.
Always tag a damaged machine and take it out
of service until repairs can be made.
WARNING: This machine requires a Portable
Residual Current Device (PRCD) also known as
a Ground Fault Circuit Interrupter (GFCI). The
110 Volt version of this machine relies on the
110 Volt transformer providing this PRCD.
Always ensure that the transformer being
used is showing no signs of damage to the
casing and that there is a reset button present.
The 230 Volt version of this machine is equipped
with its own in-line PRCD. Always use this device
whenever using the machine to reduce the risk of shock hazards.
Always position the PRCD as close as possible to the power source. Test and reset the
PRCD device before each use. Press the "Test" button to test. Press the "Reset" button
to energize the circuit to the machine.
WARNING: Always connect the plug into the wall socket with a drip loop. If the cable
leads downward directly into the wall socket, any water on the cable could run into the
socket, causing a hazard.
INTRODUCTION
This machine is equipped with two handles and a blade guard. The motor has overload and
overheat protection. It has an integrated water feed system as required for diamond cutting. It
must only be used with a diamond blade. It is intended for cutting masonry, stone, concrete,
reinforced concrete and similar materials. All other uses are prohibited.
/14
Cover
Reset Button
On Lamp
Test Button
Note: PRCD (GFCI) appearances
vary according to the requirements of
various regions. Photos for reference
only
WWW.DIAQUIP.CO.UK
LIST OF CONTENTS
Concrete Saw
Guide Roller Assembly
M17 Combination Wrench
Splash Guard
Allen Key
ASSEMBLY
Mount the blade. ( See below "Mounting the Blade")
Mount the Guide Roller Assembly if desired ( See below "Guide Roller Assembly")
Mount the blade guard brush (See below "Blade Guard Brush" for assembly instructions)
Mount the splash guard (See below "Splash Guard" for assembly instructions)
LIST OF OPTIONAL CONTENTS
Flush Cut Flange with tools & fixings
Dust Ski (Coming 2019)
400mmØ Blade
WWW.DIAQUIP.CO.UK
/15