Biometrics Direct BioCert FS-100 Інструкція з експлуатації - Сторінка 15

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для За замками Biometrics Direct BioCert FS-100. Biometrics Direct BioCert FS-100 18 сторінок.

Друкувати сторінку

Trouble Shooting

Problem
- Resolution

A fingerprint is not recognized well -

· Check whether any moisture or stains exist on the fingertip. If either of
these situations exist, wipe dry the fingertip and try again.
· Recognition capability decreases when the fingertip is too dry. In this
case, breathe on the fingertip and try again.
· Try to have the finger smoothly pressed against the scanner.
· Be careful not to move the finger as the fingerprint verification takes
place.

Beep sounds after using the door lock -

· Low Voltage warning. – This means that the voltage on the installed
batteries is dangerously low.
· Replace the batteries. If this situation persists, please contact us for
technical support.

Handle is too stiff to move -

· Bolts inside of the system should be tightened for better "fit" of the
system.
· This may be caused by mishandled installation, frequent impact, or
deformation of the shape.
· If this problem persists, contact us for technical support.

All LEDs of the system flashing, and it operates abnormally. -

· This is alerting you that all users have been cleared and you need to
register the Primary Master fingerprint.
· If this problem persists after registering the Primary Master fingerprint,
please contact us for technical support.

The system cannot start after pressing the Start button

· Low Voltage – This means that the voltage on the installed batteries is
dangerously low.
· Replace the batteries. If this situation persists, please contact us for
technical support.
Biometrics Direct – BioCert FS-100 Door Lock
Page 15