Biomorph Flexo Level3 Desk Збірка - Сторінка 16

Переглянути онлайн або завантажити pdf Збірка для Внутрішнє оздоблення приміщень Biomorph Flexo Level3 Desk. Biomorph Flexo Level3 Desk 18 сторінок.

Друкувати сторінку

Operating your Biomorph Desk

DPF1C control switch for

NOTE: DPF1C may or may not have digital display

To Raise or Lower Height in Regular Use.

button to raise

Push the

the height or the

button

to lower the height. The

system will move until the

button is released again or

the system reaches end

position.

Setting Initial Height.

It may be necessary to adjust the displayed height due to di erent

thicknesses of desktops, or addition of casters, etc. The DPF1C will as

standard either show 68 cm or 24.5 inch as the default desk height.

Procedure

5 sec.

Press

and

keys at the same time and keep them pressed

for 5 seconds. This allows the initial height to be adjusted.

Until the initial height can be adjusted, the display will show three

minuses

. Hereafter the display will revert to showing the

height. The height can then be adjusted by either

desired height has been reached. The system will return to

normal operation (and give a short blink) after 5 seconds of

inactivity on the keys.

Level

Series, Flexo Series, and Pro SuperPlus and Level 3Plus-95 desks with 5 legs.

MEMORY 1

DOWN

MEMORY 2

48.6"

22.1"

Side View

MEMORY 3

STORE MEMORY

To Set Memory.

These

memory. To store memory:

Press

. The display will ﬂash for 2 seconds. Within these two

seconds press one of these buttons

will be stored at this button.

The panel will acknowledge by showing , or in the display

depending on chosen position (if panel is included).

Memory Drive.

Press one of these memory buttons

system will start driving to the pre-programmed memory position.

Keep the button pressed until the position is reached. Release

button and press again to go past that position.

Display function (only included on dual or multiple drive tables)

shows the actual height in either cm or inch.

until

Questions? Call 888 302 3375

DIGITAL DISPLAY

buttons are used for memory drive/storing

and the position

and the