Axis 25733 Інструкція до продукту - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція до продукту для Камера спостереження Axis 25733. Axis 25733 15 сторінок.
Також для Axis 25733: Інструкція до продукту (14 сторінок)
Друкувати сторінкуELECTRICAL SPECIFICATIONS (OUTDOOR ONLY):
!
Power 24VAC, Class 2 Only
26 watts at 24 VAC (accessories)
Heater: 25 watts
Blower: 1 watt
NOTE: This unit is designed for operation in an
upright position. Installing the unit upside
down may cause damage to the internal
equipment, and will void the warranty.
GENERAL INSTRUCTIONS:
Tools Required: .100" Flat Head Screwdriver
Phillips Head Screwdriver
ASSEMBLING THE PRODUCT:
1. Remove the contents of the box onto a table. The larger
subassembly box is the housing assembly. The smaller
subassembly box is the dome assembly. (Picture 1)
2. Open the housing assembly box. Note there is a small roll
of Teflon Tape that will be needed during installation, put it
aside. (Picture 2)
Picture 1
Picture 2
Teflon Tape
3, Open the dome assembly box. Note there is a protection
film on the dome. DO NOT REMOVE the film until the
product is fully assembled and installed. This film protects
the dome from scratches during installation. (Picture 3)
4. There is a safety lanyard that is attached to the inside of
the dome assembly. Take the open end of the lanyard
and loop it around the lanyard tab that is located inside
the housing top. (Picture 4)
5. The safety lanyard is now attached to the housing.
- -
Picture 3
Picture 4