Mounting
1. If required, use the 3 supplied screws to
fix the base plate to a flat surface.
2. To use the shorter stand, remove the
extension section.
3. Attach the camera to the top of the stand.
4. Adjust the camera angle and gently
tighten the lock ring.
Important!
The AXIS 210 is designed for indoor use only, and must always be positioned where it is not exposed to
direct sunlight or strong halogen light, which can cause permanent damage to the camera's image sensor.
Damage as a result of exposure to strong light is not covered by the Axis warranty.
To use the AXIS 211 outdoors it must be installed in an approved outdoor enclosure. For more information
on outdoor enclosures, please visit www.axis.com
Cable Connections
1. Connect the AXIS 210/211 to your network using a standard RJ-45 network cable. If using
Power over Ethernet (PoE) with the AXIS 211, this is the only connection required - step 2
can be omitted. For more information on PoE, please see the User's Manual.
2. Connect the power adapter to the camera.
Installation Methods
The AXIS 210/211 is designed for installation on an Ethernet network. This involves
assigning it an IP address, using a method suitable for your network. If unsure of the
method to use, please consult your network administrator, or see the network
documentation.
•
If your network has an Internet connection (with no HTTP proxy) and uses a DHCP server to
assign IP addresses, use the One-Click installation procedure. See page 5.
•
If your network uses DHCP IP-addressing and your computer is running the UPnP™service, the
AXIS 210/211 will automatically be detected and displayed on your screen. See page 6.
•
Use the AXIS IP Utility (see page 6) to discover the IP address. This can also be used to set the
IP addess manually.
•
If you are using e.g. a home broadband router, you may find it convenient to view the router's
administration pages to discover which IP address has been assigned to your AXIS 210/211.
•
If the above methods cannot be used, assign an IP address manually using the ARP/Ping
method, as described on page 7.
Друкувати сторінку