EasyPro LED35CB Інструкція з експлуатації

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Підводне освітлення EasyPro LED35CB. EasyPro LED35CB 2 сторінки. Underwater led light strips - warm white & blue light

Друкувати сторінку

Underwater LED Light Strips

Warm White: LED11WW • LED23WW • LED35WW

Instructions for Operation • Safety • Warranty

Thank you for purchasing an EasyPro LED light strip. With this LED light you can

illuminate a pond or waterfall, highlight a deck or patio and extend the enjoyment of your

entire landscape in the evening hours. This light is fully submersible and may be used in

or out of water (fresh water only).

Maximum Watts

Safety and Electrical Connections

Always disconnect the electrical supply before handling, maintaining, repairing or

installing any pond equipment.

3. Never connect the lights directly to a 110 volt or higher outlet.

4. Not for use in swimming pools, hot tubs or bath tubs

5. Connect the transformer to a 110 volt receptacle that is protected by a Ground Fault

Circuit Interrupter.

6. Do not modify wiring in any way, quick plug ends must stay intact and should not be

replaced with terminals. DO NOT modify the white antenna on the control module.

Do not submerge control module.

7. All electrical work must be performed by a qualified technician. Always follow the

National Electrical Code (NEC) or the Canadian Electrical Code as well as all local,

state and provincial codes. Failure to follow manufacturer's installation instructions

may result in electrical shock, fire hazard, personal injury or death, damaged

equipment, provide unsatisfactory performance and will void manufacturer's warranty.

Installation of LED Light Strip

1. Before installing the product check for damaged or missing parts. Contact EasyPro

immediately if pieces are missing or damaged.

2. Be sure the power is disconnected before installing the lights.

3. Determine desired location to place the LED strip.

Note: Be sure to consider that individual diodes cannot be replaced at the end of their

life. Permanent settings may not be the best option in the case that the entire LED

strip must be replaced.

4. Place the LED strip in desired location and secure. Anchor points on both ends of

Blue: LED11CB • LED23CB • LED35CB

11" - 1.75 watts • 23" - 3.5 watts • 35" - 9 watts

Light(s) must be attached to a 12 volt AC UL listed transformer.