EasyPro ETP10 Інструкція з експлуатації, безпека, гарантія - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з експлуатації, безпека, гарантія для Насоси для ставків EasyPro ETP10. EasyPro ETP10 2 сторінки. Submersible trash pump
Друкувати сторінку
Inspection:
• Always turn off power and remove
power outlet plug from power outlet
before performing inspection
• Check regularly for drop in performance
and remove any clogged material from
inlet area, outlet hose and pipe
• Check and tighten nuts and bolts if
required
• Check with dealer for advice on other
repairs
Pump Storage:
• When the pump is out of use for an ex-
tended period - wash it, dry it and store
indoors
• Do not leave pump outdoors in freezing
conditions
• If the pump is left in water but not oper-
ating regularly, test run it at least once a
week
Disassembly and Reassembly:
• Do not attempt to disassemble pump
during warranty period
• If impeller replacement is required, con-
tact dealer for service
Warranty:
• This product is warranted against any mechanical or material defects for a period of two
years from the date of purchase (impellers are a wear item and are not covered by war-
ranty).
• This warranty does not cover accidental damage to the product due to abuse or negli-
gence by the consumer.
• In the event of a warranty claim, please return the pump postage prepaid with the
original receipt for repair or exchange. No warranty claims will be honored without the
original receipt. You must call EasyPro for an RA number before returning 800-448-3873.
• The manufacturer or supplier shall not be held liable for any damages caused by defec-
tive components or materials of this pump; or for loss incurred because of the interrup-
tion of service; or any consequential/incidental damages and expenses arising from the
production, sale, use or misuse of this product.
• The manufacturer or supplier shall not be held liable for any loss of fi sh, plants or any
other livestock as a result of any failure or defect of this product.
This pump must stay submerged entirely when operating. If used in a skimmer, the debris net must be kept clean to en-
sure adequate water fl ow to pump. Running pump low on water will cause overheating and premature failure which
is not covered under warranty.
Each year we receive numerous pumps back that simply have a small stone lodged in the impeller, are plugged from
lack of cleaning or do not work due to low voltage caused by an overloaded circuit. These are not warranty items.
Please take the time to verify your problem is actually a defective pump before returning. EasyPro will pay postage
to return pump to you provided it is a warranty issue. If you send a pump in for warranty and it checks out fi ne —
you will also be responsible for the cost of return postage.
Pump Specifi cation Table:
Specifi cations:
• Automatic overload and thermal protection with self reset
• Aluminum motor housing
• Top housings made of engineering composite with glass fi ber rein-
forcement, bottom housing is made of cast iron
• Wear resistant TPU impeller
• High precision mechanical shaft seals
• Available in manual or automatic models
ETP05 - 2" outlet, 400w, 1/2 HP, 3600 GPH, 20' cable
ETP10 - 2" outlet, 750w, 1 HP, 5700 GPH, 20' cable
www.EasyProPondProducts.com
ETP10
ETP05
Return warranty
Pond Products
4385 East 110th
Grant, MI 49327
Be sure to include RA
address and phone
number in package!
pumps to:
EasyPro
number, return