EasyPro EX11200 Посібник з монтажу та обслуговування - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з монтажу та обслуговування для Насоси для ставків EasyPro EX11200. EasyPro EX11200 4 сторінки.

We congratulate you on your choice of the EX8800/EX11200/EX13200 Centrifugal Pump! It has been carefully designed using the advan-
tages of today's technology and carefully constructed to give you the dependability of yesterday. To insure proper performance, we urge
you to carefully follow the instructions in this manual. If you have any questions, call your nearest distributor or EasyPro for assistance.
INSTALLATION
Please read carefully! When properly installed the EX8800/EX11200/EX13200 will provide dependable trouble-free service.
1. Locate the pump as near the water source as possible. A fl ooded suction situation is preferred. The pump is not self-priming, therefore,
if the fl uid level is below the pump, a swing check valve must be installed and the pump primed prior to start-up. (Figure 2)
2. Mount motor base to a secure, immobile foundation.
3. Use only plastic fi ttings on both the intake and discharge ports. Seal pipe connections with Tefl on™ paste. These fi ttings should be self-
supported and in neutral alignment with each port. (i.e. Fittings must not be forced into alignment which may cause premature line failure
or damage to the pump volute.) For non-fl ooded installations, a strainer basket and check valve are recommended.
4. Never restrict the intake. Keep both input and discharge lines as free of elbows and valves as possible. Always use pipe of adequate
diameter. This will reduce friction losses and maximize output.
5. The EX8800 is not self-priming! It must not be run dry! We recommend a fl ooded suction installation. Please read carefully! When properly
installed, the EX8800 will provide dependable, trouble-free service.
6. For additional plumbing tips, review EasyPro's website: www.EasyProPondProducts.com for pond plumbing and pump installation
hints.
WARNING: ALWAYS SHUT OFF ELECTRICAL POWER BEFORE INSTALLATION AND / OR SERVICING THIS PUMP! ALL ELECTRICAL WIRING
SHOULD MEET STATE AND LOCAL ORDINANCES. IMPROPER WIRING MAY NOT ONLY BE A SAFETY HAZARD BUT MAY PERMANENTLY
DAMAGE THE MOTOR AND/OR PUMP! 230V 50 HZ MOTORS AVAILABLE - CONTACT YOUR SUPPLIER FOR INFORMATION.
ELECTRICAL HOOK-UP
1. Check that supply voltages match the motor's requirements.
2. Check motor wiring and connect, according to instructions on motor, to match supply voltage.
3. Power cord should be protected by conduit or by cable and be of proper gauge. It should be no longer than necessary.
4. Power should be drawn directly from a box with circuit breaker protection or with a fused disconnect switch.
EX8800 • EX11200 • EX13200
SUCTION LIFT
PUMP
Reliability You Can Count On!
BALL
VALVE
FLOODED SUCTION
SWING
CHECK VALVE
(FIGURE 2)
WARNING: DO NOT RUN DRY!
© 2010 EasyPro, Inc
Pg. 2