EasyPro PA75 Інструкції з монтажу, експлуатації та технічного обслуговування - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкції з монтажу, експлуатації та технічного обслуговування для Газонна та садова техніка EasyPro PA75. EasyPro PA75 8 сторінок. Windmill aeration systems
Також для EasyPro PA75: Встановлення - Інструкції з експлуатації та технічного обслуговування (8 сторінок)

General Assembly Instructions

Unpack the aeration system to ensure all parts were received. If a shortage

occurs, please notify EasyPro immediately.

Assemble diffusers. Detailed instructions are included with each diffuser

assembly.

For Sentinel Deluxe units, the filter and valves are connected to the

compressor.

For basic kits you will need to install the inlet filter and outlet assembly.

On all basic kits, remove the compressor from the box and remove plugs

from ports on the compressor. Then assemble air filter on the inlet port and

valved outlet assembly on the discharge port. PA10 and PA12 systems are a

single line with no valve.

See images for reference of your system.

PA50 • Fig. 4c

4a. For PA10 style kits (1/20 hp DC22 Compressor)

4b. For PA12 style kits (1/8 hp DC12 Compressor)

4c. For PA50/75/100 style kits (1/4, 3/4 and 1 hp Rotary Vane Compressors)

Unroll the entire roll of tubing. It is recommended that the diffuser be installed

at this point. This will allow you to trim any unused tubing before attaching to

the compressor. Use clamps to secure tubing to outlet assembly.

Open the valves on the outlet assembly to their full open position. Plug the

compressor into a GFCI outlet and adjust each valve to equal the air flow

to each diffuser. This equalizes air flow between diffusers with different

operating depths and/or tubing lengths.

PA10 • Fig. 4a

PA75 • Fig. 4c

PA12 • Fig. 4b

PA100 • Fig. 4c