Alpha Communications TekTone NC377 Посібник з монтажу та експлуатації - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Адаптер Alpha Communications TekTone NC377. Alpha Communications TekTone NC377 12 сторінок. Paging interface adapter

Друкувати сторінку

Chapter 5—Reporting

The NC377 can store multiple days of data logs on the 1GB SD

card located on the processor board. Copy the logs to a PC

periodically. See SD Card Use in the Appendix for instructions

on copying files. If the card fills up, the oldest log will be

overwritten and lost.

A variety of report types can be produced by entering different

search parameters. Refer to Figure 10 while performing the

following steps to create a report.

Log onto the NC377 using the following procedure:

1. For the PC to communicate with the NC377 Paging Interface

Adapter, they must both be on the 192.168.1.____ IP subnet.

TekTone

suggests using 192.168.1.235. Temporarily change

the IP address of your PC or laptop. (See Changing a PC's

IP Subnet in the Appendix for instructions.)

2. Disconnect the gray crossover cable from the first NC377

slave, and use the cable to connect the PC/laptop to the

master NC377. (Reporting is not available from slaves.)

3. Open a browser, such as Internet Explorer, on the PC/ laptop.

4. Locate the NC377 Paging Interface Adapter's IP address on

the label attached to its main circuit board.

In the browser's address line, type the IP address, followed

by /default.zhtml in lower case letters. (For example,

192.168.1.239/default.zhtml)

5. The Welcome screen will appear (see Figure 5). Click on

Reports.

6. The Logon screen will appear (see Figure 6). Enter the

default user name and password:

User Name:

default

Password:

pia3264

7. Click OK.

8. The Report Options screen will appear (see Figure 10).

Page 8 • IL871 NC377 Paging Interface Adapter Manual

Log On

Report Types

Reports can be created without entering a date, room number

or type of call. Because this type of report is very general and

includes a large amount of data, it takes a considerable amount

of time to produce. Therefore, TekTone

the amount of data in a single report. Here are a few suggested

report types:

Room Number & Date—shows a list of all calls placed from a

specific room on one date or range of dates (Figure 11a).

1. Check the Date box and enter the desired From Date and

To Dates for the report.

2. Check the From Room box. Type the From Room number

and bed identifier (if used). Leave the To Room blank.

3. Click View Report.

Room Number, Date & Call Type—shows a list of calls of a

single call type placed from a specific room on one date or

range of dates (Figure 11b).

1. Check the Date box and enter the desired From Date and

To Dates for the report.

2. Check the From Room box. Type the From Room number

and bed identifier (if used). Leave the To Room blank.

3. Check the Type box. Click on the call type to highlight it

(Active, Pulse1 or Pulse2).

4. Click View Report.

Figure 10—Report Options Screen

recommends limiting