Dickinson NEWPORT Інструкція з експлуатації Посібник з експлуатації - Сторінка 15

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Обігрівач Dickinson NEWPORT. Dickinson NEWPORT 19 сторінок. Diesel heater
Також для Dickinson NEWPORT: Посібник з монтажу та експлуатації (10 сторінок), Інструкція з експлуатації та монтажу (16 сторінок)

Replace the float - Replace the float pin - Replace the top and tighten the screws

DO NOT LIGHT THE STOVE UNTIL FLOW RATE HAS BEEN CHECKED (See Page 8)

BURNER

Carbon accumulates in the burner over a period of time and it must be cleaned routinely. If you are burning

good quality fuel and the stove is burning efficiently this cleaning procedure will only be required once a

year.

IF THERE IS CARBON BUILD UP INSIDE THE BURNER THERE IS A COMBUSTION PROBLEM AND

YOU MUST REFER TO THE TROUBLE-SHOOTING SECTION OF THIS MANUAL

Cleaning Procedure

Remove the stove lid and remove the burner ring and superheater

Insert the reamer tool (provided) into the fuel inlet hole. This will prevent loose carbon falling into the

fuel inlet during cleaning.

With a wire brush, scrape any loose carbon from the sides of the burner.

Using a paper lip poke out the four rows of air intake holes on the side of the burner to ensure that they

are clear.

Remove any loose carbon from the base of the burner.

Remove the reamer and replace the burner ring and superheater. Make sure that the superheater has

the small hole end down and that the ring is lip down.

FUEL LINES

Any blockage in the fuel line from the oil-metering valve to the burner can be cleaned by removing the clean-out

plug situated directly under the burner. The plug must be replaced with tape sealant and checked for leaks.

COMBUSTION CHAMBER

This is the cemented area above the burner where the flame burns.

immediately on firing the stove.

combustion chamber will only become necessary if the cement becomes loose or detached. Replacement cement

is available from your dealer.

OVEN CLEAN OUT

Carbon may build-up around the oven. Carbon on top of the oven can be removed through the lid. To remove

carbon under the oven, remove the front panel of the stove and access the clean-panel under the oven opening.

These cracks will not affect the burning of the stove. Re-lining the

The cement will show hairline cracks