Dickson ES120A Посібник - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник для Реєстратори даних Dickson ES120A. Dickson ES120A 9 сторінок. Electronic signal data logger
Також для Dickson ES120A: Посібник із швидкого старту (2 сторінок)
Друкувати сторінку
Transmitter / Sensor
A powered transmitter is required to operate the ES120/ES120A.Any powered transmitter with a 4-20mA,
0-20mA, 0-5Vdc, 1-5Vdc or 0 to 15v (ES120A) output signal may be used. To connect a transmitter to the
logger, locate the terminal block on the side of the logger. Connect the positive wire of the transmitter to
the positive terminal and the negative wire of the transmitter to the negative terminal of the appropriate
channel. Tighten screws in terminal block to hold in transmitter wires. Repeat steps with second transmitter.
ES120
Typical Setup,
Current (mA)
ES120
Typical Setup,
Voltage (V)
ES120
ES120A
Typical Setup,
Voltage (V)
ES120-A
Rev. 02/06
+
-
Power Supply
+
CH1
-
CH1
+
CH2
-
CH2
+
-
Power Supply
+
CH1
-
CH1
+
CH2
-
CH2
+
-
Power Supply
+
CH1
-
CH1
+
CH2
-
CH2
+
Transmitter 1
-
+
Transmitter 2
-
IN Voltage
Transmitter 1
SIG OUT
GND
IN Voltage
Transmitter 2
SIG OUT
GND
IN Voltage
Transmitter 1
SIG OUT
GND
IN Voltage
Transmitter 2
SIG OUT
GND