Dickson KT6P5 Посібники з швидкого старту

Переглянути онлайн або завантажити pdf Посібники з швидкого старту для Диктофон Dickson KT6P5. Dickson KT6P5 9 сторінок. Remote sensing temperature recorder
Також для Dickson KT6P5: Початок роботи (7 сторінок)

Друкувати сторінку

DICKSON

DICK

SON

GETTING STARTED

7-day chart rotation

0 to 100

QUICK START

1. 1. 1. 1. Remove the protective pen cap.

2. 2. 2. 2. Connect Probe: Make sure the KTC probe is connected firmly to the Replaceable Sensor

and that the Replaceable Sensor is plugged in firmly to the chart recorder.

3. 3. 3. 3. Insert 4AA batteries and plug in AC adapter (See Figure 3). Unit will power on.

4. 4. 4. 4. The instrument will move pen to the appropriate readings.

5. 5. 5. 5. Install the chart that matches the Dip Switch settings (See p.4).

Press the PEN

PEN HOME

PEN

automatically raised off the chart.

Remove the old chart, place the new chart on the Chart Hub being certain that the edge

of the chart slides under the Chart Guide Clip located at the outside of the chart.

6. 6. 6. 6. Set the appropriate time. There are two ways to adjust the chart and set the appropriate

time:

a. Set the chart time manually by inserting a coin into the groove in the chart hub

and turning clockwise until the correct hour (and day if applicable) on the chart

is referenced to the timing arrow (just to the right of the pen tip on the dial).

Press Pen

Pen Home

Pen

The following feature should be used for fine adjustments only.

b. To adjust the chart time, press and hold Adjust

located on the back of the unit next to the dip switch (see Figure 3).

The green LED will blink rapidly for about five seconds, then the LED will remain

solid green. While in this state the Adjust

backward (counter clockwise) and the Adjust

forward (clockwise).

Dickson KT6P Manual V3

HOME key to move the pen to the outside of the chart. The pen is

HOME

Home to move the pen(s) back onto the chart.

Home

Remote Sensing

Remote Sensing Temperature

Remote Sensing

Adjust- - - - Up

Up and Adjust

Adjust

Adjust- - - - Up

Up button will move the chart

Adjust

Adjust- - - - Down

Down button will move the chart

Down

KT6P1 / KT6P2 / KT6P5

Temperature Recorder

Temperature

Recorder

Adjust- - - - Down

Down buttons

Adjust

Down