dicodes 2380 Посібник - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник для Електронні сигарети dicodes 2380. dicodes 2380 13 сторінок.

06 Extended Functions Menu

Additional Explanation to several menu items, page 1

The following explanations are for a few items which are not self explanatory or which have inter-

dependencies with other parameters or functions.

The selection of the correct wire-temperature-coefficient is very important for

Temperature Controlled Vaping.

NOTE: that the coefficient of stainless steel can vary depending on alloy

composition, manufacturer and production lot. For Titanium the coefficient values

also vary significantly.

The TempCof item is present, even if the operation mode is not set to Temperature

Controlled Vaping.

The Power Limit has an effect on several functions of the mod:

- Power Limit defines the range of the power selectable in the main menu. As stated

before in the main menu, the limit value sets the roll-over point of the "Power Up"

and "Power Down." The power limitation makes sense especially in the standard

vaping mode as it helps prevent coil breaks when using small atomizers and small

coils.

- Power Limit sets the power during the boost-phase in Power Boost mode.

All dicodes devices allow the user to set the minimum discharge level of the battery

between 2.5V and 3.0V (single battery, older models up to 3.5V). On the 2380 with

the use of two batteries, the discharge level can be set between 6.2 to 6.8V. Almost

all batteries specify a minimum discharge level of 2.5V to 2.7V. Since the voltage of a

fully charged battery can quickly drop to 3.7V, the protect your device the minimum

power level allowed with two batteries installed is 6.2V. If the user is unsure of the

minimum discharge level of their battery the level should be set to 2.7V when using

one battery or 6.4V when using two batteries.

The "selected voltage" is the voltage at the poles of the battery when current is

drained from it (the current drained depends on the power at the coil). In contrast to

other tube and box mods on the market—which stop operation at 3.4V

(or 7.0V)—the lower discharge level on dicodes mods lead to better battery utilization

(about 20% better).

The "time to automatic power off" of the mod can be set from 1 minute to 60 minutes.

For best battery use we recommend selecting 2 or 5 minutes in conjunction with

immediate vaping enabled ("OnClick"=0). With this combination, if the button is

accidentally pressed AND held, it's possible that the mod will exceed the maximum

vape time (error 7), the device will auto power off, then immediately turn on and so

forth in an endless loop.

To prevent this scenario, the mod has a built in safety feature: If "OnClicks"<2 AND

Error 7 (TimeOut) happens AND the mod has gone through an auto-power-off, the

mod can only be switched on by clicking the button 5 times.

As indicated, the OnClick range is from 0 (immediate vape) to 5. Note that the mod

is always on after the first click, and if the selected number of clicks is not made,

the device shuts itself off.