dicodes 2380 Посібник - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник для Електронні сигарети dicodes 2380. dicodes 2380 13 сторінок.

05 Main Menu (Page 2)

Battery Status

The Check Battery item shows the battery voltage (Ub0) and the battery voltage under

load during the last puff (UbL). The difference is the voltage drop of the battery. A high

drop (>0.4V) indicates a weak battery or contact problems.

Please note that every battery has an inner resistance and the voltage at its contacts

always drops when current is drained. The more current drained, the higher the drop.

18650 size batteries have inner resistances of about 15mOhm up to 80mOhm. Smaller

batteries even have higher resistances. Generally speaking, the batteries with high

capacity have higher inner resistance (e.g. 2500mAh NCR has 75mOhm) and those with

lower capacity have lower inner resistance (e.g. 2100mAh Sony Konion has 15mOhm).

Heater Control (Operation modes)

The mod has 5 operation modes. The default operation is either Standard (0, power

setting) or Temperature Controlled Vaping (1). With the "Expert Mode" (Extended

Functions Mod-Menu) enabled there are three additional operation modes—Heater

Protection (2), Power Boost (3), and Bypass (4, mechanical mod). With Expert Mode

disabled, menu options 2-4 are unavailable.

0. Standard Mode

In Standard Mode the wattage selected in the Power Setting menu is applied to the coil,

unless the voltage would be greater than 12V or the current greater than 15A.

For a coil resistance of 4 Ohms and a power setting of 40W, the required voltage at the coil

would be 12.7V, but given the 12V limit, he maximum wattage is 36W ((12V)²/4R=36W). Or,

if the coil resistance is 0.1 Ohm the maximum power is 22.5W, because (15A)²*0.1 Ohm

=22.5W.

With high coil resistance the power is limited by the maximum voltage (12V) and with low

resistances the power is limited by the maximum current (15A). These limits are also

reflected in the feature list: A power of 80W is guaranteed from 0.4 to

1.7 Ohms. Resistances of 0.05 to 5 Ohms are possible but with a reduced power.

1. Temperature Controlled Vaping

In this mode the mod regulates the temperature of the coil to the pre-set value unless the

power setting is too low to achieve the desired temperature. If you choose temperature

controlled vaping, please adjust the Power Level to a sufficiently high value

or the temperature regulation will change to temperature limitation mode.

2. Heater Protection Mode

The heater protection mode is a periodic interruption of the power applied to the coil.

The duration and frequency of the interrupts can be adjusted in "Heater Prot" in the

Extended Functions menu. The repeated power interrupt help avoid breaks in liquid

flow and increases in temperature.

Commented [SC1]: Are 12V and 15A device limits or preset

limits assigned to Standard Mode.

Commented [SC2]: WHAT HAPPENS GIVEN THIS VOLTAGE

IS GREATER THAN 12V?

Commented [SC3]: Does it actually switch modes or does it

the temperature regulation under a limited amount of

power function as a temperature limiter?