dicodes FL80 Посібник - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник для Контролер dicodes FL80. dicodes FL80 11 сторінок. Electronic circuit board

two (or more) batteries have different charge state when paralleling, dangerous

high currents will flow between them, which might lead to overheating and

destruction of the batteries.

2.1.3. Two Batteries in Series

It is also possible to use two Li-Ion batteries in series for higher wattage, especially

in buck operation mode (output voltage< input voltage). In this case the charging

circuit must not be connected to the batteries in series, because the charger

circuit would immediately be destroyed, as it is designed to charge one battery

only.

For use with two stacked batteries, the solder-jumper J1 MUST be removed or

shorted to the left pad (when using the dicodes balancer).

(Don't change any other jumper settings on the top side of the board.)

With two batteries, the electronic automatically activates battery supervision. The display

will show an error message and further vaping is suppressed, when either of the batteries

falls below the (programmable) minimum discharge level. When using two stacked

batteries a cable needs to be connected to the center pin of the batteries and the

"Stacking" Pad on the board (see picture above).

Nevertheless, by using the dicodes dual/triple high efficiency battery balancer board, the

charging of two batteries with the onboard charging circuitry is possible. Please follow the

wiring instructions of the balancer board for a correct setup.

Drawing 3