Alpha Microsystems Eagle 250 Посібник з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Робочий стіл Alpha Microsystems Eagle 250. Alpha Microsystems Eagle 250 20 сторінок.
Друкувати сторінкуPage 4
Printed Circuit Board Configuration
The AM-138 board is shown in Figure 4. Your board has been factory tested and shipped with its
configuration jumpers set in their standard default positions. There are only two areas on the board which
may require you to change jumper settings:
• Memory size select (JP7)
• Enabling or disabling the supply of SCSI bus termination voltage (JP5)—default set at enabled.
All other jumpers should be left in their factory-installed positions. The jumper setting table following
Figure 4 will help you check the board to make sure all jumpers are properly installed.
Eagle 250 Service Manual
Rev. 01