Alpha Microsystems AM-90 Інструкція з монтажу Посібник з монтажу - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Блок управління Alpha Microsystems AM-90. Alpha Microsystems AM-90 12 сторінок.
Друкувати сторінкуAM-90 Installation Instructions
ELECTRONIC EQUIPMENT HANDLING PRECAUTIONS
With the AC power cord unplugged and the top cover removed, the components inside your computer
are vulnerable to damage caused by static discharge. Your body and clothing can store an electrical
charge that can damage or destroy unprotected electronic components. Before handling any computer
hardware, make sure your work area is properly protected against static discharge. There are a number of
commercially available static protection devices, like the wrist strap shown below, designed specifically
to protect your equipment from harmful static discharge.
PREPARING YOUR COMPUTER
1. Ensure your work area is protected against static discharge, as outlined above.
2. Follow the instructions for accessing your computer as outlined in the Eagle Series Technical
Manual, DSS-10517-00.
3. Remove the six screws that attach the rear panel to the chassis. Remove the rear panel and lay it
down flat.
4. Unplug the existing I/O cable(s) from the CPU or system I/O board, and from the rear panel. Set
aside.
5. If you are replacing the rear panel as part of this installation, remove all the cables from the old
rear panel and attach them to the new rear panel.
PDI-00090-00, Rev. A02
Static Protection Wrist Strap
Page 3