DieHard 200.71234 Посібник користувача - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник користувача для Зарядний пристрій DieHard 200.71234. DieHard 200.71234 15 сторінок. Battery charger 6012012 amp fully automatic; 275/125 amp engine starter with battery tester and gfci outlets
Також для DieHard 200.71234: Посібник користувача (15 сторінок)
Друкувати сторінку
Before Us"
Your Battery
arger
It is important to prepare your charger for use. This section will tell you how to assemble the charger, ground
and connect the power cord, and prepare to charge a battery.
Assembling
your charger
It is important to fully assemble your charger before use.
Follow these instructions for easy assembly.
PARTS:
Two, 10-32 thread cutting
screws
Two, 1/4-20 thread cutting
sorews
Two wheels
One axle
Two axle caps
Two axle brackets
One handle
One handle grip
One mounting foot
TOOLS NEEDED:
3/8" wrench
(for mounting foot)
5/16" wrench
(for wheels)
Hammer
Phillips screwdriver
Attach Foot:
Remove charger from packing materials and place
charger on its side. Attach mounting foot and secure
with the two, 1/4-20 thread cutting screws provided.
Axle Assembly:
Hold axle upright on floor or work surface. Then, using
a hammer, tap one of the axle caps onto
the top end of the axle. Be sure to tap the hub on
straight. Slide both wheels onto the axle with the
hubs facing inward. Tap the other axle cap onto the
opposite end of the axle and place the axle assembly
onto the bottom of the charger.
continued on next page