EPH Controls EMBER Інструкція з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Шлюз EPH Controls EMBER. EPH Controls EMBER 20 сторінок.
1. Lower the cover on the front of the
RF programmer. Move the selector
switch to the 'RUN' position.
RUN
CLOCK
PROG
SET
SET
2. On the RF programmer, press the
button for 5 seconds. Wireless
Connect will appear on the screen.
Figure (7-a)
3. On the RFR wireless room
thermostat or RFC wireless
cylinder thermostat, press the
'Code' button. This is located inside
the housing on the Printed Circuit
Board.
Figure (7-b)
4. On the RF programmer, the
available zones will begin to flash.
5. Press the
the zone you wish to connect the
thermostat to.
6. The wireless symbol
the screen.
7. The thermostat will count upwards
to the number of the zone that it is
paired with. When it reaches the
number of the zone that it is paired
with press the hand wheel on the
thermostat.
8. The RF programmer is now
operating in the wireless mode.
The temperature of the wireless
thermostat is now displayed on the
programmer.
9. Repeat this process for the second,
third and fourth zone if required.
Pairing thermostats
to your programmer
button for
appears on
Figure (7-a) 'Wireless Connection' screen
Reset button Code button
Figure (7-b) Printed Circuit Board
Figure (7-c) Zone screen
7