Olympus 80 - Stylus 80 Quartz Date 35mm Camera Посібник користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник користувача для Цифрова камера Olympus 80 - Stylus 80 Quartz Date 35mm Camera. Olympus 80 - Stylus 80 Quartz Date 35mm Camera 13 сторінок. Stylus 80 instruction manual (portuguese)
Також для Olympus 80 - Stylus 80 Quartz Date 35mm Camera: Інструкція (англійською мовою) (13 сторінок), (Французька) Mode D'emploi (13 сторінок), Посібник (португальською) (13 сторінок)

Olympus 80 - Stylus 80 Quartz Date 35mm Camera Посібник користувача
SELFTIMER/REMOTE CONTROL/
16

CAMERA SHAKE INDICATOR

Mode display
No display
Secure the camera on a tripod or other support. Compose your shot in
the viewfinder. Press the shutter release button halfway (the focus and
exposure are locked at this time). Then press the shutter release button
all the way. The selftimer indicator lights for about 10 seconds and then
blinks for about 2 seconds. After this, the shutter will release.

Remote Control (Optional)

How to select the mode
Open the lens barrier. Press the
selftimer/remote control button (
The mode switches in the order shown
below. The selected mode is displayed
on the LCD panel.
Mode
———————
Selftimer
Remote Control
Camera Shake Indicator
Selftimer
Compose your shot in the viewfinder.
Position the autofocus frame on your
subject. To take a picture, point the
remote control at the camera and
press the button on the remote
control. The selftimer/remote control
indicator starts blinking, and the
shutter will release about 3 seconds
later.
Camera Shake Indicator
).
We recommend to fix the camera by using a tripod, when shooting
subjects in dark places using the flash-off mode, night scene flash
mode, or red-eye reduction night scene flash mode.
Spot marks
Closing the lens barrier restores the Auto Exposure mode.
In this mode, the camera warns
you before you shoot if camera
shake is likely to cause blurring.
Also, when there is significant
camera shake, this mode helps
reduce blurring.
If the green and orange
lamps blink alternately when
you hold the camera, it
means that the camera is
shaking and blurring may
result. Hold the camera
securely until the lamps stop
blinking; then press the
shutter release button.
Spot Metering
Setting the Spot Mode
Press the flash mode button ( ) and
the selftimer/remote control button
(
) simultaneously. Press them
again to cancel the mode.
Position the spot marks on the
area where you want to measure
the light.
Press the shutter release button
halfway; the green lamp lights and the
focus and exposure are locked on that
area. Reframe your subject and press
the shutter release button all the way.
17