Olympus DP72 Інструкція з експлуатації - Сторінка 18

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Цифрова камера Olympus DP72. Olympus DP72 40 сторінок. Microscope digital camera

To ExpressCard

Computer

PCIe Extension Box

Fig. 11

Fig. 12

Fig. 13

Connecting the ExpressCard and PCIe x1 Cable (Fig. 11)

# Insert the cable connectors all the way.

1. Insert the ExpressCard all the way into the card insertion slot* of the

laptop computer.

* ExpressCard/34 slot: Hold the card with the surface marked "INSERT"

facing up and insert.

ExpressCard/54 slot: Hold the card with the surface marked "INSERT"

facing up and insert it along the left edge of the slot.

2. Check the orientation of the connector @ of the PCIe x1 cable and insert

it into the connector on the PCIe extension box.

3. Insert the connector ² into the ExpressCard.

Connecting the AC Cable (Fig. 12)

# Insert the cable and power cord connectors all the way.

1. Insert the connector @ of the AC adapter into the connector on the PCIe

extension box.

2. Insert the connector ² of the power cord to the connector on the AC

adapter.

# Always use the power cord provided by Olympus. If no power cord is

provided with the camera head, please select the proper power cord

by referring to chapter "PROPER SELECTION OF THE POWER SUPPLY

CORD" at the end of this instruction manual.

3. Insert the power cord plug ³ into the power outlet.

# If the equipment is not grounded/earthed, Olympus can no longer

warrant the electrical safety performance of the equipment.

Connecting the External Trigger Cable (Fig. 13)

1. Insert the connector @ of the external trigger cable to the connector ²

on the PCIe interface board in the computer or the PCIe extension box.

2. When using the trigger input, connect the red cable (marked "

BNC connector ³.

3. When using the trigger output, connect the blue cable (marked "

the BNC connector |.

CAUTION

· The external triggering is available only when the DP2-

BSW Basic Software is run.

· Although the trigger input is not available for the present,

it will be enabled by updating as soon as it is ready.

" ) to the

" ) to