Olympus BXFM Series Інструкція з експлуатації - Сторінка 12

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Мікроскоп Olympus BXFM Series. Olympus BXFM Series 36 сторінок. Focusing unit

USING THE CONTROLS

Fig. 3

Fig. 4

Fig. 5

Voltage Indication

1. Ensure that the brightness control knob @ is set to MIN (lowest voltage)

then set the main switch ² to " I " (ON). (The POWER LED ³ lights.)

2. Turn the control knob @ toward MAX (highest voltage) to increase the

voltage intensity and brighten the illumination.

}The position marked

able for photography can be obtained when the U-25LBD filter is en-

gaged in the light path.

Hand Switch Operation

}When the hand switch is connected, (the REMOTE LED | lights,) the

brightness control knob @ is defeated but the brightness control knob ƒ

of the hand switch is activated.

The hand switch is supplied together with double-side adhesive tape so

that the hand switch can be used in the easiest-to-use position for each

user.

1. Press the lamp ON-OFF switch ... and adjust the brightness with the

control knob ƒ.

2. Press the lamp ON-OFF switch ... to turn the lamp OFF.

...

# When the REMOTE LED | is lit, the hand switch in standby mode

and consumes about 2.5W of power.

When the unit is not to be used for an extended period of time, set

the main switch ² to "

Placing the Specimen

Place the specimen on the stage plate @. If required, hold the specimen

with the specimen holder ².

}The specimen should be parallel and planar. Otherwise, the reflected

light cannot reach the objective, rendering observation impossible.

indicates the position with which daylight suit-

" (OFF).

(Figs. 3 & 4)

(Fig. 5)