Olympus BXFM-ILHS Інструкція з експлуатації - Сторінка 17

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Мікроскоп Olympus BXFM-ILHS. Olympus BXFM-ILHS 36 сторінок. Focusing unit

OBSERVATION METHODS (Using U-KMAS)

}For the observation methods of the BX-URA2 and BX-RLA2 reflected light illuminators, refer to their instruction manuals.

See "REFLECTED LIGHT BRIGHTFIELD OBSERVATION PROCEDURE" on page 7.

5-2 Reflected Light Nomarski DIC (Differential Interference Contrast) Observation

# The performance of polarizer may deteriorate when it has been exposed to light for a long period (about continu-

ous 2000 hours). If this happens, replace the polarizer.

# When performing sensitive color observation using the U-DICRH DIC slider, combine the U-POTP3 polarizer.

# When using the high-intensity light source, be sure to use the U-25L42 filter to prevent the polarizer from being

burnt.

Fig. 16

...

Fig. 17

Setting the Analyzer and Polarizer

# In the current step, do not engage the DIC slider in the light path.

1. Bring the specimen in approximate focusing using the 10X or 20X objec-

tive.

2. Remove the cover to enable installation of the U-AN360-3 analyzer. Then

put the analyzer @ in the insertion slot.

3. Insert the U-PO3 or U-POTP3 polarizer ² so that the surface with indica-

tion comes on the front, and engage the polarizer in the light path.

4. Rotate the analyzer rotating dial ³ to find the position where the field of

view is darkest.

}An approximate cross-Nicol position can be obtained by setting the in-

dex on the dial ³ on the outer side. Fine-adjust the dial by rotating it near

this position to find the position where the field of view is darkest.

Using the Joint Plate

When the U-AN360-3 analyzer ƒ and U-PO3 or U-POTP3 polarizer ... are

coupled by using the joint plate | provided with the polarizer and tight-

ening the clamping knobs on it, the analyzer and polarizer can be en-

gaged or disengaged in the light path together.

BXFM

(Fig. 16)