Olympus SZX16 Інструкція з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Мікроскоп Olympus SZX16. Olympus SZX16 36 сторінок. Research high-class stereo microscope
Також для Olympus SZX16: Огляд (24 сторінок), Інструкція з експлуатації (28 сторінок), Інструкція з експлуатації (40 сторінок)

Друкувати сторінку

Getting Ready

Fig. 2

Fig. 3

1. A microscope is a precision instrument. Handle it with care and avoid

subjecting it to sudden or severe impact.

2. Do not use the microscope where it is subjected to direct sunlight, high

temperature and humidity, or vibration. (For the operating environment,

see Chapter 6, "SPECIFICATIONS" on page 16.)

3. When moving the microscope, remove the specimen in advance. Then,

hold the front part of the base with one hand and hold the rear part of the

base with the other hand to avoid tilting the microscope.

Also remove any module or attachment from the microscope to minimize

the weight before moving.

4. Observe the following cautions when operating the coarse focus

adjustment knob or the zooming knob.

Operation

Manipulated Controls

Focusing

Coarse/fine focus

adjustment knobs @

(Fig. 3)

Zooming

Zooming knob ²

(Fig. 3)

5. Only one intermediate attachment can basically be used, but two

attachments may also be used though the peripheral part of the image

may be obscured.

For the coaxial vertical illuminator (SZX2-ILLC16) and reflected fluorescent

light illuminator (SZX2-RFA16), only either can be attached because they

must always be attached at the lowest position.

}The SZX2-ILLC16 is not considered to be an attachment. Therefore, the

SZX2-LBS can be mounted above it without any restriction.

Caution

1. If the knob hits the upper or lower

limiting mechanism violently or

it is rotated after it hits a limiting

mechanism, the internal

mechanism may be damaged.

2. If the knobs on the left and right

are rotated in opposite directions,

the internal mechanism will be

damaged. (The rotation tension

of the coarse focus adjustment

knob should be adjusted using

the rotation tension adjustment

ring ³ on the knob.)