Olympus ENDOCAPSULE 10 SYSTEM Посібник із швидкого старту

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Медичне обладнання Olympus ENDOCAPSULE 10 SYSTEM. Olympus ENDOCAPSULE 10 SYSTEM 2 сторінки. Preparation and settings for capsule endoscopy
Також для Olympus ENDOCAPSULE 10 SYSTEM: Короткий довідник (2 сторінок)

Друкувати сторінку

Preparation and settings for capsule endoscopy

ENDOCAPSULE 10 SYSTEM

This sheet is for quick reference only. Please refer to the instructions provided with the device for instructions in details.

Before the examination

Antenna sheet

Plates

After the capsule ingestion

After the examination

Disclaimer: Any content or information ("Content") presented herein is illustrative in nature and does not guarantee or represent specific information, outcomes, or results. Olympus Corporation, its subsidiaries, affiliates, directors,

officers, employees, agents, and representatives (collectively "Olympus") does not represent to or warrant the accuracy or applicability of the Content. Under no circumstances shall Olympus be liable for any costs, expenses, losses,

claims, liabilities, or other damages (whether direct, indirect, special, incidental, consequential, or otherwise) that may arise from, or be incurred in connection with, the Content or any use thereof.

9. Press "MENU" and select "Real Time View".

Confirm that images from the body are

received properly. If necessary, images can

be playbacked or captured.

10. Lock the button operation. Go to "Patient

Message" and press "MENU" for at least 2

sec. When patient guidance is activated, the

patient does not necessarily need to touch

the recorder. Beep or vibration will stop after

30 sec.

Note: Check that the battery is

fully charged (green lamp is lit).

11. Unlock the recorder. Press "MENU" for

12. Place recorder into the cradle.

13. A message is displayed on the screen.

1. Place recorder into the cradle.

2. Login to workstation. Register

patient information and initialize

recorder.

Refer to the back page

3. Insert the antenna sheet into the

cover between the two plates.

Orange colored lines printed on the

surface of the antenna sheet

should face front. The cable always

stay on the patient's left side.

4. Fasten the antenna belt around the

patient's body. The alignment hole

should fit the umbilical area. Wrap

the cable band around the black

belt. Make sure that the cable and

belt are tightly fixed.

5. Attach the recorder holder on the

left side of the patient's body.

Connect the recorder and the

antenna unit. Slide the connection

part until it clicks.

6. Press "POWER" for at least 1 sec.

Patient ID and name is displayed

on the upper left screen.

7. Insert the capsule activator into the

capsule container. The LED should

start blinking.

8. Press "MENU" and select "Real

Time View". Confirm that images

are received properly.

Important notice to patients

When removing capsule from the

container, be careful NOT to touch

the top cover of capsule. Otherwise,

clear images may not be captured.

more than 2 sec. Open "Real Time

View" to confirm that the examination is

complete.

Click "OK" to start downloading image

data. When completed, a check mark is

displayed on the main screen.