Olympus OEP-5 Інструкція з експлуатації - Сторінка 12
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Медичне обладнання Olympus OEP-5. Olympus OEP-5 40 сторінок. Color video printer
Друкувати сторінку
2.3 Connection to the
AC Mains Power
Supply
DANGER
Always power this instrument from a wall mains outlet
that has an exclusive terminal for grounding this
instrument. Otherwise, fire or electric shock may result.
WARNING
• Strictly observe the following precautions for the
2
power cord. Damaging the power cord may result in
fire or an electric shock:
Moreover, if the power cord is damaged, turn OFF the
power and stop using this instrument immediately and
contact Olympus.
– Take care to place the cord such that it is not crushed
between the instrument and a wall, mobile
workstation or a shelf, etc.
– Do not modify or damage the power cord.
– Do not use damaged power cord.
– Do not stretch or place a heavy object on the power
cord.
– Do not place the power cord near heating equipment
or expose it to excessive heat.
– Always grasp and pull the plug when unplugging the
power cord. Do not pull on the cord itself.
• Always use this instrument with the voltage specified
in "Specifications" on page 32 in "Appendix". With an
incorrect supply voltage, fire and/or electric shock
may result.
• If there is metal and/or dust on the power cord plug or
near the plug of the power cord, disconnect the power
cord and remove it with a dry cloth. Otherwise, fire
and/or electric shock may result.
• Always use the power cord and connection cables that
were shipped with this instrument or mobile
workstation. Using other power cords or connection
cables may result in electric shock and/or malfunction.
• Do not allow the power plug to become wet. Also do
not hold the power cord with a wet hand. A wet power
plug may cause electric shock.
• Confirm that the wall mains outlet has adequate
electrical capacities. Failure to do so may cause fire or
a power failure to all of the equipment connected to
the same power circuit.
• Do not bend, pull or twist the power cord. Equipment
damage, including separation of the power plug or
disconnection of the cord wire, as well as fire or
electric shock, can result.
• Do not use the adapter that the power cord plug
changed into 3-pin to 2-pin. Electric shock may result.
12
2.3 Connection to the AC Mains Power Supply
CAUTION
• Use a power supply that suits the specifications in
"Specifications" on page 32 in "Appendix."
Otherwise, malfunction may result.
• Be sure to connect the power plug securely.
Otherwise, the equipment will not function.
• Do not use of a power supply with insufficient
electrical capacities. Otherwise, malfunction may
result.
• Be especially careful not to allow the power cord to
become disconnected. If the power cord disconnects
during use, any picture being printing will be lost, or
may not be printed correctly.
• Do not connect or disconnect the power cord while
power is ON. Otherwise, malfunction may result.
To connect to the AC mains power supply
1
Confirm that the color video printer (OEP-5) is
turned OFF.
Power switch
Figure 2.3
2
Connect the power cord provided with the mobile
workstation to the AC mains power inlet of the
color video printer (OEP-5) (see Figure 2.4).
AC mains power inlet
Power cord
Figure 2.4
3
Connect the power cords of the ancillary equipment
to the mobile workstation by referring to the
respective instruction manuals.